Bedienungsanleitung Westfire WF32 (Seite 13 von 36) (Deutsch, Englisch, Holländisch, Dänisch, Französisch)

813316

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

WESTFIRE · WF32 WESTFIRE · WF32

Hearth

The hearth should be able to accommodate the weight of the stove and its chimney if the chimney is not

independently supported.

The WESTFIRE WF32/UNIQ32 INSET wood inset stove has been tested and is suitable to be installed above a 12 mm

non combustible plate such as Westﬁre 12 mm glass plates or 20 mm slate plates. Installation of the stove must be

at a minimum height of 450 mm for 12 mm hearth. Installation of all hearths should comply in size and construction

so that it is in accordance with the provisions of the current Building Regulations Approved Document J.

The clearance distances to combustible material beneath, surrounding or upon the hearth and walls adjacent to

the hearth should comply with the guidance on the separation of combustible material given in Building Regula-

tions Approved Document J and also in these stove instructions.

If the stove is to be installed in front of a wooden ﬂoor, it must be covered with a non-combustible material at

least 12 mm thick, in accordance with Building Regulations Approved Document J, to a distance of 30 cm in front

of the stove and 15 cm to each side measuring from the door of the combustion chamber.

Combustion air supply

In order for the stove to perform efﬁciently and safely there should be an adequate air supply into the room in

which the stove is installed to provide combustion air. This is particularly necessary if the room is double-glazed

or a ﬂue draught stabiliser is operating in the same room as the appliance. The provision of air supply to the

stove must be in accordance with current Building Regulations Approved Document J. An opening window is not

appropriate for this purpose. Air inlets must be positioned in such a way that they cannot be blocked. An air inlet

may be a vent (the vent must be open and the capacity of the vent sufﬁcient when the stove is lit) or a fresh air

system linked to the stove.

The WESTFIRE WF32/UNIQ 32 INSET has an option of a closed air supply collar; this enables the stove to take all

combustion air (primary, secondary and tertiary) directly from outside with a 100 mm pipe from the stove.

FLUE AND AIR INTAKE POSITIONS

WF32/UNIQ32

INSET

Distance from rear to centre of top ﬂue exit 167 mm

Distance from ﬂoor to centre of rear ﬂue exit 405 mm

Distance from bottom of appliance casing to centre of Air intake 70 mm

Westﬁre Insulated chambers

The WESTFIRE WF32/UNIQ32 stove is lined with heat deﬂection panels and bafﬂes, these panels are designed

to ensure the maximum efﬁciency and are an integral part of the clean burn process of the stove. These bafﬂes

should not be removed other than for cleaning the stove. Any defective panels should be replaced.

Commissioning and handover

Ensure all parts (ﬁre brick sets, grates) are ﬁtted in accordance with the instructions given in the instruction

booklet.

On completion of the installation allow a suitable period of time for any ﬁre cement and mortar to dry out, a

small ﬁre may be lit to check that smoke and fumes are taken from the stove up the chimney and emitted safely

into the atmosphere. Do not run at full output for at least 24 hours.

On completion of the installation and commissioning ensure that the operating instructions for the stove are left

with the customer. Ensure to advise the customer on the correct use of the appliance with the fuels likely to be

used on the stove and notify them to use only the recommended fuels for the stove.

Advise the user what to do should smoke or fumes be emitted from the stove. The customer should be warned to

use a ﬁreguard to BS 6539 in the presence of children, aged and/or inﬁrm persons.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Westfire WF32 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info