Bedienungsanleitung Westfire WF32 (Seite 19 von 36) (Deutsch, Englisch, Holländisch, Dänisch, Französisch)

813316

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

WESTFIRE · WF32 WESTFIRE · WF32

Only speciﬁc SE models are suitable for smoke control areas, alterations should not be attempted.

Westﬁre smoke control stoves should not be burnt with the door left open.

The refuelling procedure : - allow the newly charged fuel to burn with the secondary air control set at maximum

for up 3 to 4 minutes. After this period, with ﬂames from the logs fully established, close the secondary air supply

to the low output setting. When operating at high output (secondary air set fully open) the new refuel charge

does not require any boost air to establish combustion.

RE-FUELLING WHEN BURNING WOOD

BURNING WOOD IN A SMOKE CONTROL AREA

To re-fuel your stove in the cleanest way only refuel your stove when ﬂames have died down and you have

glowing embers. Before refuelling, open air controls fully and slide. Unlatch door to equalise pressure with the

room. Open door gently, add one piece of wood WESTFIRE UNIQ32 and close the door. Once the ﬂames from the

logs are fully established move air control to nominal position. The stove is only suitable for intermittent use only:

do not run overnight or for long periods unattended.

Experience will determine the settings that produce best results. Use a ﬂue thermostat to check the stove is not

overheating. Flue thermostats should be placed directly above collar of the stove on a non insulated section of

pipe. (efﬁcient operating temperature range is between 200c and 400c?)

SE MODELS – smoke exemption modiﬁcation

Smoke exempt models are factory ﬁtted with a air stop on the air control slider:

Refuelling on to a low ﬁre bed

If there is insufﬁcient burning material in the ﬁrebed to light a new fuel charge, excessive smoke emission can

occur. Refuelling must be carried out onto a sufﬁcient quantity of glowing embers and ash that the new fuel

charge will ignite in a reasonable period. If there are too few embers in the ﬁre bed, add suitable kindling to

prevent excessive smoke.

Operation with door left open

Operation with the door open can cause excess smoke. The appliance must not be operated with the appliance

door left open except as directed in the instructions.

Dampers left open

Operation with the air controls or appliance dampers open can cause excess smoke. The appliance must not be

operated with air controls, appliance dampers or door left open except as directed in the instructions.

Fuel Overloading

The maximum amount of fuel speciﬁed in this manual should not be exceeded, overloading can cause excess

smoke.

Annual service

The inside of the stove should be serviced /cleaned once a year. To clean the inside, remove all ash, soot and tar

residue from the combustion chamber. Remove insulated chamber panels and bafﬂe, to clean out any dirt and

soot will collected behind them. Check the quality of all insulated panels and replace any which are damaged or

cracked, replace stove door rope cord in the door. Check glass is correctly positioned.

The stove, the ﬂue pipe connection and the chimney should be checked regularly by a qualiﬁed engineer. The

chimney should also be checked for blockages before relighting the stove if it has not been used for an extended

period of time.

Stove Log length & weight

WF32 4 pieces approx 22 cm, 2.1 kg

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Westfire WF32 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info