Bedienungsanleitung Whirlpool ACE 102 IX (Seite 32 von 298) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

662567

Zoom out

Zoom in

Vorherige Seite

1/298

Nächste Seite

GB30

• Coffee has been used to factory test the machine and it is therefore completely normal for there to be traces of coffee in

the mill.

• Customize water hardness as soon as possible, following the instructions in paragraph Setting water hardness.

1. Connect the appliance to the mains power supply. Set the desired language.

2. Scroll using the buttons (B5 and B6) until you find the desired language (Figure 2). When the display shows:

PRESS OK TO INSTALL ENGLISH, press the OK button (B7) (Figure 3). If you select the wrong language, follow the

instructions in paragraph Setting the language. If, on the other hand, your language is not available, select one of those

displayed. English is the reference language for the instructions. Next, follow the instructions indicated on the display.

3. After 5 seconds, the display shows FILL TANK !: remove the water tank (Figure 4), rinse and fill to the MAX line with fresh

water then replace in the machine.

4. Place a cup underneath the hot water spout (Figure 5). (If the water spout is not inserted, the appliance displays the

message INSERT WATER SPOUT !: insert it as shown in Figure 6. The display shows HOT WATER. PRESS 'OK'. Press OK (B7)

(Figure 3) and after a few seconds, water runs out of the spout.

5. The display shows TURNING OFF. PLEASE WAIT... and switches off.

6. Slide the machine out, using the handles provided (Figure 7); open the lid, fill the coffee bean container, then close the lid

and push the machine back into the housing.

The coffee machine is now ready for normal use.

N.B.:

• When using the appliance for the first time, you need to make 4/5 cups of coffee and 4/5cappuccinos before the

appliance gives good results.

• Each time the machine is turned on using the main ON/OFF switch (A23) it runs the SELF-DIAGNOSIS function and then

switches off: to switch back on again, press the (A7) on/stand-by button (Figure 1).

Each time the machine is switched on, it performs an automatic preheat and rinse cycle which cannot be interrupted. The

machine is ready for use only after completion of this cycle

To switch the appliance on, press the (A7) on/stand-by button (Figure 1): the display shows HEATING UP. PLEASE WAIT.... After

heating, the display shows another message: RINSING. The machine is at working temperature when the display shows

MEDIUM CUP STANDARD TASTE.

USING THE APPLIANCE FOR THE FIRST TIME

WARNING

Never place pre-ground coffee, freeze-dried coffee, caramelized coffee or foreign objects

in the container, as they could damage the machine

SWITCHING ON AND PREHEATING

WARNING

Risk of burns! During rinsing, some hot water is run off from the coffee spouts.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ACE 102 IX Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info