Bedienungsanleitung Whirlpool ACM 702 (Seite 7 von 8) (Englisch)

73076

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Care and maintenance

Clean the hob after each use in order to avoid damaging

the surface and to prevent the formation of baked-on

deposits which are difficult to remove. Before cleaning,

make sure the cooking zones are switched off and that the

residual heat indicator (“H”) is not displayed.

• Never clean the hob with a steam cleaner!

• Periodically check for dust under the

appliance, near the cooling air inlet or the

outlet openings. This could hinder the

ventilation and cooling of the electronic

module and decrease the effectiveness of the

hob.

To clean the hob, proceed as follows:

1. use a soft clean cloth, absorbent kitchen wipes or a

proprietary cleaner for glass ceramic hobs. Do not use

abrasive sponges and/or metal scouring pads.

2. Food spills should be cleaned off before they bake

onto the glass ceramic surface. Sugar and foods with a

high sugar content damage the glass ceramic surface

and must be immediately removed using a scraper for

glass. Caution! Glass scrapers have a very sharp blade

and must be handled with care.

3. Remove any stubborn food residues with a scraper or

proprietary detergents.

4. Salt, sugar and sand can scratch the glass ceramic hob:

clean up any such spills on the hob immediately.

Troubleshooting Guide

• Before contacting After-sales Service:

• read and follow the instructions given in the section

“Operating instructions”.

• Connect the hob to the electricity supply and check that

the supply has not been shut off.

• Clean the hob and dry it thoroughly.

• If, when the hob is switched on, alphanumeric codes

appear on the display, consult the following table for

instructions.

Important! If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately from the

power supply.

After-sales Service

Before contacting After-sales Service:

• Try to solve the problem (see “Troubleshooting

Guide”).

• Switch the appliance off, wait 30 seconds then switch it

on again. to see if the fault persists.

If after the above checks the fault persists, contact the

nearest After-sales Service.

Always provide:

• a brief description of the fault;

• the exact type and model;

• the service number (number after the word Service on

the rating plate) is located on the underside of the

cooktop or on the warranty booklet;

• your complete address and phone number.

If any repairs are required, please contact an authorized

After-sales Service as indicated in the warranty.

Spare parts available for 10 years.

MAINTENANCE

ERROR CODE DESCRIPTION POSSIBLE CAUSES REMEDY

The hob switches off

and after 30 seconds

emits an acoustic signal

every 4 seconds

Continuous pressure on

control panel area

Water or utensils on control panel Clean the control panel

C81, C82

The control panel switches off

because of excessively high

temperatures

The internal temperature of

electronic parts is too high

Wait for the hob to cool down

before using it again

F42 or F43

The connection voltage is

wrong

The sensor detects a discrepancy

between the appliance voltage and

that of the mains supply

Disconnect the hob from the

mains and check the electrical

connection

F12, F21, F25, F36,

F37, F40, F47, F56,

F58, F60

Call the After-Sales Service and specify the error code

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ACM 702 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ACM 702

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info