Bedienungsanleitung Whirlpool ACM 808 (Seite 13 von 39) (Englisch, Französisch, Italienisch)

521476

Zoom out

Zoom in

Vorherige Seite

1/39

Nächste Seite

INSTALLATION INSTRUCTIONS

Electrical connection

Before connecting the appliance, make sure:

1. the mains voltage in your home matches that specified on the appliance dataplate;

2. the electrical system adequate for appliance max. power absorption specified on the dataplate;

3. the house electrical system is suitably earthed.

• Connect the appliance to the power supply by means of a suitable disconnecting switch with

min. contact opening distance allowing complete disconnection in category III overvoltage

conditions, in compliance with the installation regulations.

Notes: After installation, the electrical components must only be accessible with the use of a special tool.

The power cable must be H05VV-F type and electric connections must be in compliance with below

electric information.

3 x 2.5 mm 400 V ~ 50 Hz 4 x 1.5 mm 400 V~ 50 Hz

Instructions for the installer

Warning

• Disconnect the appliance from the power supply before carrying out any repairs or

operation.

• Installation must be carried out by a qualified technician, in compliance with the current

safety regulations.

• The appliance must be earthed.

The Manufacturer declines any liability for injury or damage to people or property due to non-

compliance with the above-mentioned regulations. The appliance dataplate is located at the bottom

right of frame of the oven cavity and visible with the door open. Adjustment conditions are given on a

label on the packing.

Do not use the oven door for handling operations, or for removing the appliance from the packing.

ELECTRICAL CONNECTION AND SAFETY

For the electrical connection, make sure to follow the instructions given below:

• The earth wire must be connected to the earth terminal ( ). If there is no approved earthed

electrical outlet in the place where the appliance is to be installed, immediately contact to our

Authorised Service.

• The earthed electrical outlet must be close to the appliance. Do not use extension cords.

• The power cable must not touch hot parts of the product.

• If the power cable is damaged, contact a Qualified Service Centre. The cable must be replaced by

the Authorised Service.

• An incorrect electrical connection could damage your appliance. Such damage is not covered by

the warranty.

• The appliance is arranged for a 400 Volt power supply. If the power supply voltage is different,

immediately contact to our authorised service.

The power cable must not touch hot parts of appliance, otherwise it may become damaged.

This situation could cause short circuiting.

The manufacturer declines any liability for damage and loss due to failure to comply with the

following safety regulations.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ACM 808 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ACM 808

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info