Bedienungsanleitung Whirlpool ADG 7530 (Seite 7 von 8) (Englisch)

539862

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

5. WHAT TO DO IF...

If a fault occurs,

before

contacting the After-Sales Service, make the following checks to try and remedy the

problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal

appliance operation.

The appliance... Possible causes/solutions

...is not working/will not start - The appliance must be switched on.

- Check the household circuit fuse if there is no power supply.

- The dishwasher door must be closed.

- Check whether the “Delayed Start” option has been selected (if

available). If it has, the appliance will only start once the set time

has elapsed. If you want to start the appliance before that time,

set the start delay to “0” (RESET).

... shows “F6 / E2” on the display or the

Cancel/Off light flashes alternately

6 times / 2 times

- The water tap must be open.

- The water inlet hose must not be kinked and the relative inlet

filter in the water tap connector must not be dirty or clogged.

... shows “F6 / E7” or “F6 / E1” on the

display or the Cancel/Off light flashes

alternately 6 times / 7 times or

6 times / 1 time

- The water tap must be fully open during water inlet (minimum

capacity: 0.5 litres per minute).

- The water inlet hose must not be kinked and the relative inlet

filter in the water tap connector must not be dirty or clogged.

... shows “F6 / E3” on the display or the

Cancel/Off light flashes alternately

6 times / 3 times

- The filters must not be dirty or clogged.

- Concave items (e.g. bowls, cups) must be arranged facing

downwards in the rack.

- The drain hose must be fitted correctly (for raised built-in

appliances, leave min. 200-400 mm from the lower edge of the

appliance - see instructions in “Maintenance and Installation”).

... shows “F8 / E1” on the display or the

Cancel/Off light flashes alternately

8 times / 1 time

- The filters must not be dirty or clogged.

- The drain hose must not be kinked.

- The retaining washer of the syphon hose connection must be

removed.

... shows other faults “F.. / E..” on the display

of the Cancel/Off light flashes X times

- Reset the appliance (see below).

After taking the above course of action, no fault message should be displayed.

In the majority of cases the fault is thus eliminated.

RESET:

➯

Press the Cancel/Off button.

➯

Water drains automatically for up to 60 seconds with the door closed.

➯

The appliance is now ready to be restarted.

Crockery... Possible causes/solutions

...are not perfectly clean/have food residues - Arrange crockery so that items do not touch each other.

Concave items (e.g. bowls, cups) must be arranged facing

downwards in the rack.

- If necessary, use more detergent, observing the manufacturer's

indications as regards dosage. Always store detergent in a dry

place and do not store it for excessively long periods of time.

- For heavily soiled crockery, select a wash programme with a

higher temperature (see table 1.1 on the first page).

- If you select the “Half load/Multizone” option (if available),

remember to load

only

the upper rack or

only

the lower rack

to increase aspersion and thus obtain optimum wash results.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ADG 7530 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ADG 7530

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info