Bedienungsanleitung Whirlpool ADG9927 (Seite 1 von 4) (Englisch)

3472

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91638

ADG 9927

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/FD/GB

(We reserve the right to make technical modifications)

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately

before starting a wash programme.

Time and failure display

Indicates in hours the time remaining until the start of

the wash cycle. Toward the end of the programme,

during the drying cycle, the display will indicate the time

remaining in minutes.

“F....” Identification of faults for service technician

“Delayed start” button

The wash cycle can be programmed to start after 1 - 24

hours. With each successive touch of the button, the

delayed start indicator increases by 1 hour, and after 24

returns to 00. Then press the Start button. The

dishwasher will start at the set time.

“Half load - Multizone” button

Load the upper or lower rack only.

This function can be used with any programme.

Press once = upper rack

(the indication lamp/symbol comes on)

Press twice = lower rack

(the indication lamp/symbol comes on)

Press 3 times = Off (half load function deactivated).

When washing without the top rack, press the “Half

Load” button twice, or “Lower rack wash” (the

corresponding LED/symbol comes on).

Set detergent

(when the appliance is used for the first time and when

using a different type of detergent)

Off indicator = detergent (powder, gel, tablets)

Left indicator =2 in 1 detergent

Right indicator = 3 in 1 / 4 in 1 detergent

Antibacterial rinse

4) 5)

This function adds an antibacterial rinse at the end of the

wash cycle, thereby guaranteeing a perfectly clean and

sanitized load. The lamp will light up when the function

is activated. If the temperature is not maintained during

the antibacterial cycle (e.g. if the door is opened and

remains open for a long time), the lamp will start

blinking to indicate that sanitation is not guaranteed.

1) Reference programme for energy label EN 50242;

2) Refer to “User instructions”;

3) Programme data obtained in conformity with European

standard EN 50242. Values may vary in relation to usage,

e.g.: different loads, options, water temperatures - above

or below 15°C - as well as water hardness and power

supply voltage, etc.

4) The bacteria removal efficiency has been tested by the

Institut Pasteur de Lille (France), based on the NF

EN 13697 standard of November 2001.

5) These programmes can be used with the Antibacterial

rinse option.

6) Energy saving programme with prolonged drying cycle.

On button

Off button

Programme selection button

The selected programme is shown in the

window of the display.

Start button

Switches “on” when the dishwasher is

operating. Flashes when a fault occurs.

Switches off at the end of the programme.

Reset button

After pressing the Reset button, the selected

programme and the supplementary functions

are cancelled (except the detergent and water

hardness settings, see user instructions) and

must be reset. On releasing the button this is

confirmed by an acoustic signal.

Indicators

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B

Litres kWh Minutes

Sensor Normal

40-55°C

Automatic programme recommended

for routine washes, with no dried-on or

burnt food (not for EN 50242).

X X 10.0-13.0 0.80-1.05 60-120

Sensor Intensive

60-70°C

Automatic programme recommended

for heavily soiled crockery with dried-on

or burnt food, for example pans and

saucepans.

X X 13.0-20.0 1.10-2.00 100-150

Pre-Rinse cold

Crockery to be washed later. - - 4.0 0.03 14

Glass 40°C

Light soiling, for example glasses and

cups.

X - 10.0 0.85 100

Quickwash 40°C

Lightly soiled crockery with no

dried-on food.

X - 10.0 0.65 30

Bio

1) 5) 6)

50°C

Normally soiled crockery. X X 13.0 1.05 195

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ADG9927 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ADG9927

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info