Bedienungsanleitung Whirlpool ADP 6940 (Seite 1 von 4) (Englisch)

75360

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

Whirlpool is a registered trademark of Whirlpool USA

5019 396 91557

ADP 6940

Quick Reference Guide

Before using the dishwasher, read the user instructions!

WH/I/B/GB

(We reserve the right to make technical modifications)

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately before

starting a wash programme.

Time and failure display

Indicates in hours the time remaining until the start

of the wash cycle. Switches off when the

programme starts and indicates the time remaining

in hours and minutes.

“F....” Identification of faults for service technician

“Delayed start” button

The wash cycle can be programmed to start after

1 - 24 hours. With each successive touch of the button,

the delayed start indicator increases by 1 hour, and

after 24 returns to 00. Then press the Start button.

The dishwasher will start at the set time.

Antibacterial rinse

This function adds an antibacterial rinse at the end of

the wash cycle, thereby guaranteeing a perfectly clean

and sanitized load. The lamp will light up when the

function is activated. If the temperature is not

maintained during the antibacterial cycle (e.g. if the

door is opened and remains open for a long time), the

lamp will start blinking to indicate that sanitation is

not guaranteed.

“Half load - Multizone” button

Load the upper

lower rack

only

This function can be used with any programme.

Press once = upper rack

(the indication lamp/symbol comes on)

Press twice = lower rack

(the indication lamp/symbol comes on)

Press 3 times = Off (half load function deactivated).

When washing without the top rack, press the

“Half Load” button twice, or “Lower rack wash”

(the corresponding LED/symbol lights up).

1) Reference programme for energy label EN 50242

(Liter = 13.0, kWh = 1.05, Min. = 120);

2) Refer to “User instructions”;

3) Program data obtained in conformity with European

standard EN 50242. Values may vary in relation to usage,

e.g.: different loads, water temperatures - above or below

15°C - as well as water hardness and power supply

voltage, etc.

4) The bacteria removal efficiency has been tested by the

Institut Pasteur de Lille (France), based on the NF

EN 13697 standard of November 2001.

5) These programmes can be used with the Antibacterial

rinse option.

Programme selection button

On / Off button

Start button

Switches “on” when the dishwasher is operating.

Flashes when a fault occurs. Switches off at the end

of the programme.

Indicators

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B

Litres kWh Minutes

Sensor max

1) 5)

40-70°C

Lightly, normally or heavily soiled, also

suitable for pans and saucepans.

X X 7.0-17.0 0.99-1.58 60-146

Pre-Rinse cold

Crockery to be washed later. - - 4.0 0.03 14

Glass 40°C

Light soiling, for example glasses and

cups.

X - 10.0 0.80 55

Quickwash 40°C

Lightly soiled crockery with no

dried-on food.

X - 10.0 0.65 30

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ADP 6940 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ADP 6940

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info