Bedienungsanleitung Whirlpool ADPU 8773 (Seite 1 von 8) (Englisch)

660514

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

GB -1-

Chart

(see at right for options description)

PROGRAM SELECTION

BUTTON

Push “P” button (repeatedly)

until selected program number

is shown on the display

(P1...Px) - see “Table of

programs” below.

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute

(0:01 is shown into the display).

If pressed when the dishwasher is switched off,

it drains any possible liquids from dishwasher

(1 minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on conditions. Differences of up

to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the EN/Standard loading comparison test

and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deter-

gent

Consumption

Drying

Phase

Programs

Available

options

Loading instructions

Litres kWh

Minutes

6th Sense

Power Clean

40°-70°C

Delay

Half Load

Power Clean

Use for normal soiled dishes with dried-on food.

Senses the level of soiling on the dishes and adjusts

the program accordingly. When the sensor is

detecting the soil level an animation appears in the

display and the cycle duration is updated. The

Power Clean option is activated automatically with

this program. To deactivate, press the Power

Clean button on the control panel.

X 7-14 1.00-1.65 80-165 Full

Pre-Wash cold

Delay Crockery to be washed later.

— 4.0 0.03 14 NO

Fragile 40°C

Delay Light soiling, for example glasses and cups.

X 10.0 0.85 100 Light

Rapid 45°C

Delay Lightly soiled crockery, with no dried-on food.

X 11.0 0.80 30 NO

Eco

50°C

Delay

Half Load

Power Clean

Normally soiled crockery.

Energy-saving program.

X 11.0 1.03 185 Full

Fast Daily 60°C

Delay

Half Load

Normally soiled crockery.

X 10.0 1.30 80 Full

Silent 50°C

Delay

Normally soiled crockery, gentle and

quiet thanks to the lower spray pressure (39 dBa).

X 13.0 1.20 290 Light

Intensive 65°C

Delay

Power Clean

Recommended program for heavily soiled

crockery, especially suitable for pans and

saucepans.

X 14.0 1.60 145 Full

Steam

Delay

Power Clean

Program including steam action dedicated for

heavily soiled crockery, pots and pans. Soaking or

hand pretreatment is no longer needed.

X 14.0 1.70 180 Full

P10

Hygiene

Delay

Power Clean

Normally or heavily soiled crockery, with additional

antibacterial wash. Program interruption (e.g. due to

door opening) can compromise elimination of germs.

X 13.0 1.50 118 Full

5019 396 03665

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS

QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:min).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY

BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

POWER CLEAN

Thanks to the additional

power jets this option provides

a more intensive and powerful

wash in the lower rack, in the

specific area. This option is

recommended for washing

pots and casseroles (see page

4). Press this button to activate

Power Clean (the indicator

lights up). For non Power

Clean loading to achieve best

cleaning performances and

resources optimization, Power

Clean should be switched off.

TABLET SETTING

This setting allows to

optimize the cycle

performances according

the type of detergent

used. Push the Tablet

button for 3 seconds (until

the indicator lights up) if

you are using the

combined detergents in

tablet (rinse aid, salt and

detergent in 1 dose).

If you are using powder

detergent or liquid

detergent, the Tablet

indicator on the control

panel has to be off.

DELAYED START

BUTTON

Push the button

(repeatedly) to delay the

start of the program.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed

start indicator increases

by one hour and after

24 restarts from 0.

Then press the START

button. The dishwasher

will start after the set

time.

HALF LOAD BUTTON

Half load cycle can be used for the

upper or lower rack. Select the

required program then press the

“Half Load” button - the light comes

on. Turns off at the end of the

program.

The “Half Load” option can be used

with the programs indicated in the

table of programs.

Quick reference guide

Whirlpool ADPU 8773 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info