Bedienungsanleitung Whirlpool AFG 8220 (Seite 2 von 2) (Englisch)

112003

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 603 01036

D F NL E P GR

S N FIN

IGB

PRODUCT SHEET

Freezer compartment temperature adjustment

The appliance is normally factory set for optimum operation at a temperature of -18°C.

To alter the internal temperature between -16°C and -24°C, proceed as follows:

• Press button E once to adjust the internal temperature: the digital display shows the temperature previously

set.

• Each time the button is pressed, the temperature setting is changed by 1°C: the value (between -16°C and

-24°C) blinks cyclically on the display.

• Approximately 5 seconds after the button has been pressed for the last time, the set temperature is stored,

the display stops blinking and the current internal temperature is shown on the display.

• The 6th Sense function (blue LED) is automatically activated due to door opening and when small amounts

of fresh food are placed in the freezer. The duration of the 6th Sense function varies depending on the

quantity of food loaded in the freezer and ambient temperature. When optimal operating conditions have

been restored the function deactivates automatically and no operation is required.

Note:

The digital display shows internal temperature values between +10°C and -24°C.

In the event of a power failure, selected functions remain stored in the memory.

Fast freezing

The fast freeze function switches off automatically when freezing is complete.

Alarm signals

Note:

The temperature alarm may activate if the door is left open for a prolonged period of time or following the

introduction of fresh food in the freezer compartment; this temporary rise in temperature does not affect the

storage of already frozen food in any way.

Defrosting (for No Frost models no operation is required)

This appliance defrosts automatically according to usage and ambient humidity conditions.

Follow the steps detailed in “Switching on the appliance”.

For not No Frost models, follow step 1-6:

Signal Cause Solution

Door open alarm

The acoustic alarm is activated The door has been left open

for more than 1 minute

Close the door

Temperature alarm

The acoustic alarm and red LED C

are activated

The internal temperature is

above -12°C

Press button G; wait for

the temperature to fall

below -12°C again

Te m p e r a t u r e s e n s o r

alarm

The acoustic alarm is activated and

the display shows “SF”

Temperature sensor fault Contact After-sales

service

Prolonged power failure

alarm

The acoustic alarm and red LED C

are activated; the display blinks,

indicating the highest temperature

reached following the power failure

Prolonged lack of power

supply, causing the internal

temperature to rise to very

high values at which correct

food storage cannot be

guaranteed

Press button G; the

display now indicates the

current internal

temperture

1. Press the freezer on/off button D. An illuminated dot appears on the digital display.

2. Unplug the appliance or switch off at the main

switch.

3. Fit the drain in place (see figure).

4. Follow the instructions given in the

instructions booklet.

5. Plug in the appliance once again.

6. Press the freezer on/off button D. Follow the steps detailed in “Switching on the

appliance”.

60301036GB.fm Page 2 Tuesday, March 18, 2008 5:56 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool AFG 8220 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool AFG 8220

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info