Bedienungsanleitung Whirlpool akr 400 ix (Seite 4 von 4) (Englisch)

128986

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

AFTER-SALES SERVICE

Before calling After-Sales Service



See if you can solve the problem yourself with the

help of the Troubleshooting guide.



Switch off the hood for a few minutes and re-start it

to see if the problem has cleared itself.



If the malfunction persists, call After-Sales Service.

Specify:



the nature of the problem,



the model,



your full address,



your telephone number and area code.



The service code (number below the word SERVICE

on the rating plate inside the hood behind the

grease filter).

INSTALLATION

When installing the hood, the minimum distances from the cooktop must be respected, and the numerical

sequence and additional instructions must be followed exactly as indicated on the Installation sheet.

External Exhaust Mode

(

- see also installation sheet)

Cooking fumes and vapours are conveyed outside through a duct connected to the hood by means of a collar.

The outlet duct diameter must be the same as that of the collar.

If a flue-damper is to be installed, check that it can open and close freely when installation of the exhaust

duct is complete.

The hood can be supplied with one (upper) or two (upper and rear) exhaust outlet holes.

The hood is usually set up for using the upper exhaust outlet.



The collar must be seated in the upper exhaust outlet.

Use the rear exhaust outlet (where present).



Where fitted, remove the cover closing off the rear outlet and collar.



Some models are fitted with a plastic deflector that closes off the rear outlet. If fitted, remove it.



Fit the collar in the rear outlet.



Put the cover (if fitted) in the upper outlet.

Warning! If the hood has a carbon filter, this should be removed.

Check that the switch inside the hood (if fitted) is in position

A Extractor

; if not, set it to this position.

Air Circulation Mode

(

- see also installation sheet)

The air is filtered by a carbon filter and recycled into the surrounding atmosphere. The filtered air is released

towards the kitchen ceiling.

Warning! If the hood does not have a carbon filter, order one and fit it before use.

Check that the switch inside the hood (if fitted) is in position

F Filter

; if not, set it to this position.

If the plug is provided, close off the upper exhaust hole.

Electrical connection

Before connecting the hood, make sure the voltage indicated on the rating plate corresponds to the voltage in your

home.

The plate is located inside the hood behind the grille.

For GB this appliance is supplied without a plug and is intended for direct connection to fixed wiring in accordance

with national wiring regulations. An all-pole disconnection switch with a minimum contact separation of 3 mm

must be included in the fixed wiring in an easily accessible position.

The Manufacturer shall not be liable for any damage or problem arising from the failure to comply with the

above-mentioned instructions.

3gb33015.fm5 Page 35 Thursday, August 23, 2001 12:50 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool akr 400 ix Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool akr 400 ix

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info