Bedienungsanleitung Whirlpool akr 953 ix (Seite 4 von 6) (Englisch)

128995

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

CARE AND MAINTENANCE

TROUBLESHOOTING GUIDE

Hood does not work:

• Is the power plug properly inserted in the mains

socket?

• Is there a power failure?

• Is the mains fuse OK?

Insufficient suction power:

• Is the right extraction speed selected?

• Do the filters need to be cleaned or replaced?

• Are the air outlets blocked?

Light does not work:

• Does the bulb need to be replaced?

• Is the bulb correctly fitted?

• Is the mains fuse OK?

Never try to carry out any repair by yourself other

than fixing the above-mentioned problems.

Always disconnect the hood before cleaning or carrying out maintenance by unplugging it or switching

off the power supply.

Grease filter

• The sponge grease filter should be washed in hot soapy water once a month

(soak for 1-2 hours, do not wring, leave to dry and then remount. If necessary, repeat the process. Replace with

a new filter every 5-6 washes).

• The grease filter paper should be replaced at least once a month.

• Grease filter paper with saturation indicator should be replaced at least every two months or whenever the

colour becomes visible through the holes of the grille.

The paper filter is coloured on one side. This colour should not be visible through the grille holes when the filter

is installed.

• Metal grease filters should be washed once a month either by hand or in a dishwasher at a low temperature and

in a short cycle. Leave filter to dry before remounting it. Washing in a dishwasher can cause grease filters to turn

white, but this in no way affects efficiency.

Whenever cleaning or replacing the grease filters, clean all other exposed parts of the hood.

Carbon filter

(“Air recirculation mode”, see following page)

The carbon filter cannot be washed or regenerated. In some cases, carbon filters can be washed, but only when

specified in the attached Product Description Sheet.

Replace the carbon filter (normal usage)

every 6 months (Rectangular carbon filter)

every 4 months (Circular carbon filter).

Replacing bulbs

1. When replacing the bulb, be sure it is cool before touching it and check the wattage.

2. Pull out the steam-collecting drawer (depending on model).

3. Open the grille or light fixture and remove the grease filter.

4. Remove the burnt-out bulb and replace it with a new one of the same wattage. Close the grille, light fixture or

metal grease filter.

Cleaning the hood

Use a soft cloth with methylated spirits or a mild liquid detergent. Never use abrasive substances. never clean the

appliance with high pressure water or steam cleaning equipment.

WARNING: Failure to remove oil/grease (at least once a month) could result in fire.

Important: Failure to observe the instructions for cleaning the appliance and replacing or washing the filters may

cause a fire.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool akr 953 ix Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool akr 953 ix

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info