GB9
After unpacking the appliance, check for any damage caused during transport. In case of problems, contact the dealer or the After-Sales Service. To avoid any
damage, it is advisable to only remove the appliance from the polystyrene base just before installation.
PREPARATION FOR INSTALLATION
this appliance is heavy; the hood should only be lifted and installed by two or more people.
The minimum distance between the cooking pan support on top of the cooker and the bottom of the hood must not be less than 50 cm for electric cookers and
65 cm for gas or mixed cookers.
Before installation also check the minimum distances stated in the manual of the cooker.
If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed.
ELECTRICAL CONNECTIONS
Make sure the power voltage specied on the appliance rating plate is the same as the mains voltage.
This information may be found on the inside of the hood, under the grease lter.
Power cable replacement (type H05 VV-F 3 x 0.75 mm²) must be carried out by a qualied electrician. Contact an authorized service centre.
If the hood is tted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is tted
(direct wiring to the mains), or if the socket is not located in an accessible place, install a standardized double pole power switch that will enable complete
isolation from the mains in case of category III overvoltage conditions, in accordance with wiring rules.
GENERAL RECOMMENDATIONS
Before use
Remove cardboard protection pieces, transparent lm and adhesive labels from accessories.
Make sure the appliance has not been damaged during transport.
During use
Do not place weights on the appliance, as they could damage it.
Do not expose the appliance to atmospheric agents.
WARNING:
Disposal of packing
The packing material is 100% recyclable and is marked with the recycle symbol . The various parts of the packing must be disposed of responsibly and in
full compliance with local authority regulations governing waste disposal.
Disposal of the appliance
- This appliance is marked in compliance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
- By ensuring that this appliance is disposed of correctly, you can help prevent potentially damaging consequences for the environment and health.
- The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an
appropriate collection centre for the recycling of electrical and electronic equipment.
INSTALLATION
SAFEGUARDING THE ENVIRONMENT
