GB11
- use protective gloves.
- disconnect the appliance from the power supply.
GREASE FILTERS
The metal grease lter has an unlimited life and should be cleaned once a month by hand or in
a dishwasher at low temperature and with a short cycle. Cleaning in a dishwasher may cause
discoloring of the grease lter, but its ltering eciency is unaected.
Open the perimeter extraction panel.
Pull out the handle to remove the lter.
Wash the lter and leave it to dry, proceeding in reverse order to ret.
PANEL
Removal:
pull the panel rmly towards you and release it from all the xing points.
Cleaning:
the panel must be cleaned as often as the grease lter, using a cloth dampened with neutral
liquid detergent.
Avoid the use of products containing abrasive substances. DO NOT USE ALCOHOL!
Fitting:
The panel must be xed onto the special pins on the hood.
Warning! always check to ensure that the panel is rmly xed in place.
REPLACING LAMPS
The hood lighting system is based on LED technology.
The LEDs provide optimal illumination, a lifetime up to ten times longer than traditional
lamps but with 90% less energy consumption.
Contact the technical support service for replacements.
CARBON FILTER
(lter hoods only)
It captures and neutralizes unwanted cooking odours.
Change the carbon lter every 4 months
Fitting or changing the carbon lter
- Open the perimeter extraction panel
- Remove the grease lter
- Fit the round carbon lters, one on each side, to cover both motor protection grilles, then
turn clockwise.
Note: Proceed in reverse order to remove.
Proceed in reverse order to ret the grease lters in place.
WARNING:
MAINTENANCE
