Bedienungsanleitung Whirlpool AKZM 838 (Seite 12 von 64) (Englisch)

483349

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

GB10

SETTING END OF COOKING TIME / DELAYED START

The end of cooking time can be set, delaying the start of cooking by up to a maximum of 23 hours and 59 minutes. This can only

be done once cooking time has been set. This setting is only possible when pre-heating is not required for the selected

function.

After setting cooking time, the display shows the end of cooking time (for example 19:20). To delay the end of cooking time, and

thus also the cooking start time, proceed as follows:

1. Position the cursor next to the end of cooking time using buttons .

2. Press button to select the setting: the end of cooking time flashes.

3. To delay the end of cooking time, use buttons and to set the desired value.

4. Confirm the selected value by pressing button .

5. Press button . The display indicates which shelf food should be placed on.

6. Press button to activate the function. The oven will start cooking after a period of time calculated so as to finish

cooking at the set time (for example, in the case of a dish which requires a cooking time of 20 minutes, if the end of

cooking time is set to 20:10, the oven will begin cooking at 19:50).

N.B.: During the interval before cooking starts, the oven can in any case be switched on by pressing button .

At any time during cooking, set values (temperature, grill setting, cooking time) using buttons and button

as described in previous paragraphs.

INDICATION OF THE RESIDUAL HEAT INSIDE THE OVEN

If at the end of cooking, or when the oven is switched off, the temperature inside the oven is high, on some models the display

shows the current temperature and the bar indicating cooling in progress. Once the oven chamber has cooled down, the display

shows the current time again.

TIMER

This function can be used only with the oven switched off and is useful, for example, for monitoring the cooking time of pasta.

The maximum time which can be set is 1 hour 30 minutes.

1. With the oven switched off, press button : the display will show “00:00:00”.

2. Press buttons and to select the desired time.

3. Press button to start the countdown. When the set time has elapsed, the display will show “00:00:00” and an acoustic

signal will sound. At this point the time can be prolonged, proceeding as described above, or the timer can be deactivated

by pressing button (the time of day will be shown on the display).

PREHEAT

TEMPERATURE

180°C

HH:MM

END TIME

Forced Air

19:20

- 00:20

PREHEAT

TEMPERATURE

180°C

HH:MM

END TIME

Forced Air

19:20

- 00:20

PREHEAT

TEMPERATURE

180°C

HH:MM

END TIME

Forced Air

20:10

- 00:20

Residual Heat

168°

19:42

Press to set Timer, ✓ to Start

00 : 00 : 00

(HH) (MM) (SS)

Press to set Timer, ✓ to Start

01 : 10 : 00

(HH) (MM) (SS)

Timer

01 : 09 : 00

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool AKZM 838 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool AKZM 838

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info