5019 301 05827
Whirlpool is a registered trademark of Whirlpool USA
Add the detergents as described in the programme
table or in the chapter “Detergents and Additives”
in your Instructions for Use bookl et.
1. Switch on the machine by pressing the
“On/Off”
-button.
2. The blue indication lights of the main programmes
and of the “Reset” button light up.
3. Select the desired programme by pressing the
corresponding button. The blue lamps of the other
programmes go out , and the lamp of the
“Start/
Pause”
button flashes. The display shows the
predefined spin speed and temperature
corresponding to the selected programme.
4.
The temperature can be altered by pressing the
temperature selection buttons
“+/-”
, the spin
speed by pressing the spin speed selection button
. If spin speed “0” is selected, the final spinning
is cancelled, but intermediate spin peaks rema in
during rinse; the water is drained out only.
• W ash your laundry in the desired programme
(Cotton, Synthetics), adding an appropriate
amount of chlorine bleach to the SOFTENER
chamber (close the detergent dispenser
carefully).
• Immediately after end of programme, start the “Rinse
and Spin ” programme to eliminate any residual bleach
smell; if you want, you can add softener .
Selecting any s pecial option the indica tion lights up.
When the combination of programme, a dditional
options and temperature is not possible, the indication
lights switch off automati cally. Unsuitable
combinations of op tions are deselected auto matically.
“Eco+” button
• With a modified temperature profile and a
slightly prolonged washing duration, the
optimum combination of excellent washi ng
result and even lower energy consumption can
be achieved.
“Easy Ironing” button
• Can be used together with “Cotton”, “Synthetics”
and “Daily ” programmes to make ironing easier .
• Increases the water quantity and the clothes are
spun very soft.
“Pre wash” button
• Only for heavily soiled loads (for example sand,
granular dirt) sensible. The cycle time increases
approximately 15 min.
“Intensive Rins e” button
• More water and a longer time in rinse cycle is added.
• This option is particularly suitable for areas with
very soft water , washing baby linen and helps
people with allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to avoid
creasing and prevent colou rs from changing.
CONSUMPTION DATA
Pro gr a mm e
T emperature
Selector
(°C)
Load
(kg)
Wa t e r
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
*
Cotton (Anti-bacterial) 95 6.0 54
**
1.90 2:00
Cotton 60 6.0 49 1.14 2:20
Cotton with Eco+
***
60 6.0 49 1.02 2:30
Cotton 40 5.0 44 0.60 2:05
Synthetics 60 2.5 55 0.80 1:30
Synthetics 40 2.5 55 0.60 1:20
Daily load 40 3.0 45 0.50 1:00
Quick wash 30 3.0 37 0.40 0:30
Delicate 30 1.5 60 0.50 0:45
W ool 30 1.0 60 0.30 0:40
Handwash (Lingerie) 30 1.0 45 0.30 0:40
Prewas h cycle might increase programme duration. Consum ption values were measured in normalized conditions in compliance
with Standard IEC / EN 60 456. Consumption data in the home may vary with respect to the values in the ta ble in relation to the
water supply pressure and temperat ure, the load and the typ e of wash.
*
The remaining time indicator can similarly deviate from the values in the table, becaus e it takes into account the household
conditions applicable at that time. When the remaining programme duration is newly calculated, the 6
th
Sense symbol
appears on the display .
**
T o reduce the water temperature, some co ld water is added at the end of the main wash cycle, before the pump drains the wate r out.
***
Reference programme for the energy labe l.
ADD DETERGENTS, CLOSE THE DOOR
AND SELECT THE PROGRAMME
USING CHLORINE BLEACH
SELECT SPECIAL OPT IONS
• This option is particularly recommended for the
programme “Syn thetics”, “Daily ” and “Delicates”.
• T his function is particul arly useful if you want to
postpone spinning to a later time, or if you want
to drain only .
Note:
The programme stops to “Rins e Hold” at
the time the “Rinse Hold” symbol is indicated on
the display. The
“Start/Pause”
button flashes.
T erminate the “Rinse Hold” option:
•P r e s s t h e
“Start/P ause”
button; the
programme w ill terminate automatically with the
final spin cycle for the pr esent wash programme.
• If you do not wish to spin the clothes, press the
“Reset” button and afterwar ds the
“Start/
Pa u s e ”
button to start the “Drain ” programm e.
You have the possibility to store, for each main
programme, your preferred combi nation of
programme, options, temperatur e and spin speed.
After having selected the desired combination,
press the
“Favourites”
button for at least 3 sec.
Next time yo u choose the corresponding
programme, the display will show you the stored
parameters, and you just have to press
“Start/
Pause”
. If you want to change the stored
combination, just make your new choice and again
press the “Favourites” button for at least 3 sec.
The previous combination is cancelled
automatically, and the new one is stored.
The “Start Delay” allows to run the machine at the
consumer’s convenience, for example at night when
electricity is c heaper.
• Sel ect programme, temperature, spin speed and
options.
• P ress the “Start Delay ” button to select the
delay time by 1 to 23 hours. The selected start
delay is indicated on the display under
“Remaining Time”.
•P r e s s t h e
“Start/P ause”
button - the
countdown of the selected start delay begins.
• The start delay indic ation disappears when th e
programme starts and is replaced by the
remaining time.
• The number of hours can be mod ified later by
pressing the “Start Delay ” button again.
T o cancel the “Start Delay ”
• P ress the “Reset” button for at least 3 seconds -
the start delay time disappears from the
remaining time indication.
Open the tap and press the
“Start/Pause”
button.
The blue lamp under the
“Start/Pause”
button
stops flashing and lights up. The display indicates the
sequence reached in the programme by the
corresponding symbol. When the programme
sequence is finished, the corresponding symbol
disappears. Under “Remaining Time”, the display
indicates the remaining programme duration.
As long as a washing programme is running, the lamp
lights up to show that the door cannot be opened. When
the indication goes off, the door can be opened again.
“Clean filter”
Waste water is not pumped out. Check whether the
drain hose is kinked or the filter must be cleaned; in
the latter case refer to the Instructions for Use
(“Removing the Filter”).
“Water tap closed”
The appliance has no or insufficient water supply. Open
the water tap; if the in di c at i on still lights up, re fer to the
“Troubleshooting Guide” in the Instructions for Use.
• On the display , the “Remaining time” disappears
and “End” is indicated.
1. Sw itch th e machine off by pressing the
“On/Off”
-button.
2. Close the water tap.
3. Open the door and unload the machine.
4. L eave the door ajar to allow the drum to dry out.
1. Press the
“Start/Pause”
button to pause the
programme. The light flashes.
2. Select the new programme (with temperature),
any options and another spin speed if you want .
3. Press the
“Start/Pause”
button again. The ne w
programme continues at the same position where
the previous programme was interrupted. Do not
add detergent for this programme.
•P r e s s t h e
“Reset”
button for at least 3 seconds.
Any existing water is drained out before the
door can be opened.
FAVOURITES
START DELAY
PRO G RA M ME S T AR T
BLUE “DOOR LOCKED” INDICA TION
RED INDICA TIONS
PROGRAMME END
CHANGE THE PROGRAMME,
TEMPERATURE, OPTIONS AFTER
PROGRAMME START
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
30105827GB.fm P age 2 Tuesday, Dece mber 27, 2005 4: 32 PM
Black process 45.0° 100. 0 LPI