CONSUMPTION DA
Cons
may
* The
ap
** T
*** Re
ADD DETERGENTS, CL
SELECT THE PROGRAMME
SELECT ANY DESIRED OPTION
“DOOR OPEN” INDICA
Before starting and after end of a programme, the lamp
lights to show the the door can be opened. As long
as a wash programme is running, the door remains
locked and must on no account be forced open.
In case you have an urgent need to open it during a
running programme, refer to “Cancel (Reset) a running
programme before the end”.
RED INDICA
“Service”
Lighting up of the “Service” indication can be caused
by a fault in an electrical component. Refer to the
“T
if the fault persists, contact our After Sales Service.
“
The appliance has no or insufficient water supply
the water tap: if the indications still lights up, refer to the
“T
“Clean pump”
W
drain hose is kinked or the filter must be cleaned: in the
latter case refer to the Instructions for Use (“Removing
the Filter
Push the button(s) of any option(s) desired - the
respective indication lamp lights up.
When the combination of programme and additional
option(s) is not possible, the indication lights switch off
automatically
deselected automatically
“Clean+” button
• Choose this option if you use an in-wash additive for
stain removal (powder
optimize the additive’s efficiency to get better wash
performance and stain removal.
• Selectable for programmes “
Cotton
choose temperature of 30 or 40°C and use with
maximum load.
• Add an appropriate amount of in-wash additive for
stain removal (powder) to the main wash chamber
together with your detergent (only use powder
detergent with this option).
PROGRAMME ST
Open the tap and press the “Start” button. The
indication lamp next to the “Start” button lights up.
The programme sequence indicator shows the current
programme phase, running from left to right through
W
The time display shows the remaining programme
time. Due to variations in load and temperature of inlet
water
programme phases. If this is the case, an animation
appears on the time display
PROGRAMME END
• All the lights of the programme sequence indicator
are off
1. T
position.
2. Close
3. Open
4. Leave
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME ST
1. P“Start/Pbutton to pause the
programme.
2. Select
options and another spin speed if you want.
3. P“Start/Pbutton again. The new
programme continues at the same position where
the previous programme was interrupted. Do not
add detergent for this programme.
CANCEL (RESET) A RUNNING PROGRAMME
BEFORE THE END
Th“
• Press the “Reset” button for at least 3 seconds;
“
is drained out before the door can be opened.
Respect the manufacturer’s dosing instructions.
• Pr
• Appropriate for use of stain removers and bleaches
on oxygen basis. Chlorine or perborate bleaches
must not be used!
“Prewash” button
• Only for heavily soiled loads (for example sand,
granular dirt) sensible. Increases the cycle time by
approximately 15 min.
• Do not use liquid detergent for the main wash when
activating the “Prewash” option.
“Easy ironing” button
• Can be used together with “Cotton
and “Daily load” programmes to make ironing easier
• Increases the water quantity and the clothes are spun
very gently
“Intensive rinse” button
• More water is added and rinse cycle is prolonged.
• This option is particularly suitable for areas with very
soft water
allergies.
“Rinse hold” button
• The laundry remains in the last rinse water without
pregressing to the final spin cycle to avoid creasing
and prevent colours from changing.
• This option is particularly recommended for the
programmes “Synthetics”, “Daily load” and
“Delicates”.
• It is particularly useful if you want to postpone
spinning to a later time, or if you want to drain only
• If you select “Rinse hold” do not leave items to soak
for
The “Start delay
consumer
electricity is cheaper
Do not use liquid detergent when
activating “Start delay
• Select
• P
time
• P“Start/P button.
The
delay” indication lamp and the dot on the display will
keep
• The
programme
programme
• Once “Start/Pause” button, the
number
pressing
T
...before you press the “Start/P
• T
press “Reset” button.
...after having pressed the “Start/P
• P
start
ST
Add detergents as indicated on the front page and as
described in the chapter “Detergent and Additives” in
your Instructions for Use.
1. Tprogramme selector to the desired
programme
2. The time display shows the duration of the chosen
programme
“Start/P” indication lamp blinks.
3. The indication lamp of the predefined spin speed
lights
Note:
The programme stops to “Rinse hold” at the
time the “Rinse hold” lights in the preogramme
sequence indication is on. The indication lamp next
to the “Start” button blinks.
T
• P“Start/P button; the programme
will
for
• If
programme
and “Start/P button.
“
• Every
• P
• If
cancelled
rinse.
5019 301 01069
Whirlpool is a registered trademark of Whirlpool USA.
Programme
T
(°C)
Load
(kg)
W
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)*
Cotton 95 5.0 49** 1.90 2:00
Cotton *** 60 5.0 44 0.85 2:20
Cotton 40 5.0 44 0.60 2:00
Synthetics 60 2.5 50** 0.70 1:30
Synthetics 40 2.5 45 0.55 1:15
Sport 30 2.5 55 0.65 1:29
Delicates 30 1.5 50 0.50 0:45
Daily load 40 3.0 45 0.45 1:00
Quick wash 30 3.0 40 0.40 0:30
W
40 1.0 55 0.60 0:45
Handwash 40 1.0 45 0.60 0:40
Handwash 30 1.0 45 0.50 0:36
