Bedienungsanleitung Whirlpool AWO 9141 (Seite 9 von 13) (Englisch)

539733

Zoom out

Zoom in

Vorherige Seite

1/13

Nächste Seite

TROUBLESHOOTING GUIDE

Depending on the model, your washing machine is

equipped with various automatic safety functions.

This enables faults to be detected in good time and

the safety system can react appropriately. These

faults are frequently so minor that they can be

removed within a few minutes.

The washing machine will not start, no

indicator lamps are on.

Check whether:

• the mains plug is inserted into the socket

• the wall socket is functioning correctly (use a

table lamp or similar appliance to test it)

The washing machine will not start... and the

“Start/Pause” indicator lamp flashes.

Check whether:

• the door is properly closed (child safety);

• the “Start/Pause” button has been pressed.

In models with LCD display, the display shows:

• the water tap is closed. For models with a

“Water tap closed” indicator lamp, the red

indicator lamp lights up. Open the tap and press

the “Start/Pause” button.

The appliance stops during the programme

(varies depending on model)

Check whether:

• the “Rinse Hold” indicator lamp is flashing;

terminate this option by pressing the button

again

In models with LCD display: the “Rinse Hold”

option has been preselected and the “Rinse

Hold” symbol appears on the display; cancel this

option by pressing the “ ” button or select

the “Drain” programme

• another programme has been selected and the

“Start/Pause” indicator lamp is flashing. Reselect

the desired programme and press the

“Start/Pause” button

• the door has been opened and the “Start/Pause”

indicator lamp is flashing. Close the door and

press the “Start/Pause” button again. In models

with LCD display, the display shows: “PAUSE!”

• the washing machine's safety system has been

activated (see “Fault display chart”)

Residue from detergent and additives left in

the detergent drawer at end of wash.

Check whether:

• the siphon is correctly installed and clean (see

“Care And Maintenance”)

• sufficient water is entering.

The mesh filters of the water supply could be

blocked (see “Care And Maintenance”)

• When using powder detergent beforehand the

coloured insert for dosing liquid detergent has

been removed from the dispenser

Machine vibrates during spin cycle.

Check whether:

• the washing machine is level and standing firmly

on all four feet

• the transit bolts have been removed. Before

using the machine, it is imperative that the

transport bolts are removed

Final spin results are poor.

The washing machine has an imbalance detection

and correction system.

If individual heavy items are loaded (e.g. bathrobes),

this system may reduce the spin speed

automatically or even interrupt the spin completely

if it detects too great an imbalance even after

several spin starts, in order to protect the washing

machine.

In models with LCD display, in the event of an

imbalance, the display shows:

• If the laundry is still too wet at the end of the

cycle, add smaller articles of laundry and repeat

the spin cycle

• Excessive foam formation may prevent spinning.

Use the correct amount of detergent

In models with LCD display, the display shows:

• Check that the spin speed selector has not been

set to “0”

30105536aGB.fm Page 25 Thursday, December 30, 2004 10:53 AM

Black process 45.0° 100.0 LPI

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool AWO 9141 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool AWO 9141

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info