Bedienungsanleitung Whirlpool awoe 9558 (Seite 10 von 17) (Englisch)

308191

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

EN 9

CARE AND MAINTENANCE

Appliance exterior and control panel

• Wash down with a soft, damp cloth. Dry with a

soft cloth.

Appliance interior

• After each washing, leave the door open for some

time to allow the inside of the appliance to dry.

• If you never or seldom wash your laundry at

95 °C, we recommend to occasionally run a

95 °C programme without laundry, adding a

small amount of detergent, to keep the interior

of the appliance clean.

Door seal

• Dry the door seal after each washing with an

absorbent cotton cloth; make sure that the

door seal is completely dry before closing

the door of the empty washing machine.

• Check the condition of the door seal

periodically.

Filter

• Check and clean the filter regularly, at least two

or three times a year (see “Draining Residual

Water/Cleaning The Filter”).

Do not use detergents containing solvents, scouring powder, glass or general purpose

cleaners, and flammable fluids. They may harm the plastic surfaces or other parts.

Cleaning the detergent dispenser

1. Pull out the dispenser drawer until it stops. Press with your

finger on the small depression over the “PUSH” marking

(fig. “A”) to release the drawer and pull it out completely.

2. Remove the siphon from the softener chamber by pulling it

upwards (fig. “B”). If available, also remove the insert for liquid

detergent from the main wash chamber and remove the

coloured siphon part (fig. “C”).

3. Wash all the parts under running water.

4. Clean the dispenser compartment with a damp cloth.

5. Refit the siphon in the softener chamber by pushing it down

until it stops; if your washing machine has an insert for liquid

detergent, add the coloured siphon part to the insert again.

Then push the dispenser drawer back into the dispenser

compartment.

Water supply hose(s) (picture D, E or F - depending on

model)

Check regularly for brittleness and cracks. In case of a damage,

replace it by a new hose of the same type, available through our

After-Sales Service or your specialist dealer.

If the inlet hose of your washing machine corresponds with

the model on picture “E”, periodically check the safety valve

inspection window: if it is red, the hose’s waterstop function was

triggered, and the hose must be exchanged by a new one from

our After-Sales Service or your specialist dealer. This model may

have a release lever which must be pressed down while

unscrewing the hose.

If your supply hose has a transparent hose coating (fig. “F”),

periodically check the colour; if it intensifies locally, the hose may

have a leak and should be replaced. Contact our After-Sales

Service team or specialist dealer to obtain a replacement hose.

Cleaning the mesh filter in the water supply hose(s)

1. Close the tap and loosen the inlet hose on the tap.

2. Clean the internal mesh filter and screw the water inlet hose

back onto the tap.

3. Now unscrew the inlet hose on the rear of the washing machine.

4. Pull off the mesh filter from the washing machine connection

with universal pliers and clean it.

5. Refit the mesh filter and screw the inlet hose on again.

6. Turn on the tap and ensure that the connections are

completely water-tight.

Control window

Release lever

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool awoe 9558 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool awoe 9558

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info