Bedienungsanleitung Whirlpool awz quality (Seite 2 von 2) (Englisch)

302687

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 307 00043

1. Check that all fastenings are closed and that

pockets are empty.

2. Turn the articles inside out.

3. Place laundry loosely in the drum to make

sure it doesnt become tangled.

Sort laundry as follows:

A) By care symbols

(on the collar or inside seam):

Suitable for tumble drying

Tumble drying with reduced drying

intensity only

Do not tumble dry

B) By amount and thickness/weight

Whenever the load to be dried exceeds dryer

capacity, separate laundry according to

weight (e.g. towels from thin underwear).

C) By type of fabrics

Cotton/linen

: Towels, cotton jersey, bed

and table linen made of cotton or linen.

Synthetics/Easy Care

: Blouses, shirts, overalls,

etc. made of polyester or polyamide, as well as

cotton/synthetic mixes.

D) By drying level

 Sort into: iron dry, cupboard dry, etc.

Do not tumble dry:

Woollens, silk, nylon

stockings, delicate embroidery, fabrics with

metallic decorations, bulky items such as

sleeping bags, etc.

Important: only use specific indicated dryer-

safe additives

and rinse items that have been

treated with stain remover thoroughly in plenty

of water before drying.

Only use specific

indicated dryer-safe plastic items

and never

dry rubber or articles contaminated with

vegetable oil in the dryer.

When opening the door, with a programme selected,

the inside light (if supplied) will switch on to

facilitate the loading and unloading of the dryer.

How to use the child safety lock:

1. Open the door.

2. Using a coin or a screwdriver, turn the plastic

screw clockwise by 90°.

Slot vertical:

the door cannot be locked.

Slot horizontal:

the door can be locked.

Programme and Options:

 To select a programme, turn the programme

selector knob to the required position.

 To select an option (if available), press the

corresponding button. The button lights up,

confirming that a selection has been made.

An alarm sounds if an incorrect selection is

made (incompatible options).

 Press the option button again to cancel the

option.

1. Having selected the desired programme and

options, press the Start/Pause button.

If the laundry is not removed at the end of

the drying cycle, an automatic anti-crease

cycle will operate for maximum 60 min. The

drum rotates at regular intervals, preventing

the laundry from creasing for 12 hours if the

option anti-crease has been selected.

2. On completion of the programme, set the

programme selector knob to position 0.

The dryer indicator lamp Start/Pause

switches off.

When changing the programme during the drying

cycle, the dryer stops. The indicator lamp of the

Start/Pause flashes.

To operate the new programme, press the Start/

Pause button.

To interrupt the dryer during operation

1. Set the programme selector knob to Airing.

2. Press the Start/Pause button.

Wait at least 5 minutes before opening the

door to allow the dryer to cool down.

For your safety the programme stops

automatically if you open the door.

3. To restart, after door opening, close the door

and press the Start/Pause button again.

Clean the lint filter at the end of every drying

cycle:

1. Open the door.

2. Pull the filter upwards.

3. Open the filter.

4. Remove lint using a soft brush or your fingertips.

5. Close the filter.

6. Push the filter firmly back into place

Empty the water container at the end of every

drying cycle.

1. Pull the handle to remove the water container.

2. Empty the water container.

3. Replace the water container when empty by

pushing it

completely

back in place.

When installing your dryer, always carefully

level the dryer by means of the adjustable

feet and check the correct levelling with a

spirit level.

Clean the heat exchanger at least every 3

months. Wipe away any lint/fluff from the

door seal and interior using a damp cloth.

(Please refer to instructions for use)

To built in the dryer

Remove the work-top and replace it with the Built-

In kit UBS 10 (according to Eec Electrical

Regulations), which can be ordered at your dealer.

If a fault occurs, before contacting our After-

Sales Service, make the following checks to

try and remedy the problem:

Drying takes too long / laundry is not dry enough:

 Was the correct programme selected?

 Was the inserted laundry too wet (Washing

machine spin speed less than 800 rpm? When

the spinning speed is less than 800 rpm the

water container fault may occur during the

drying cycle.)?

 Is the lint filter dirty (filter indicator lamp on)?

 Is the heat exchanger dirty? (refer to the

Instructions for use)

 Is the ambient temperature too high?

The dryer does not operate:

(after a power failure and/or interruption to

the mains supply, always press the Start/

Pause button).

 Is the plug properly inserted into the mains

electricity socket?

 Is there a power failure?

 Has the fuse blown?

 Is the door properly closed?

 Has the programme been selected?

 Has the start delay option been selected?

 Has the

Start/Pause

button been pressed?

Lint filter or water container indicator lamp

light on:

 Is the lint filter clean?

 Is the water container empty?

 Is the water container correctly positioned?

 Is the heat exchanger clean?

Water droplets underneath the dryer:

 Is the heat exchanger correctly positioned?

 Has any fluff on the heat exchanger seal

been wiped away?

 Has any fluff on the door seal been wiped away?

 Has the water container been positioned

correctly?

Replacing inside light bulb (if supplied):

 If the inside lamp does not work, the bulb

may be faulty.

 Unplug the dryer.

 Open the door and unscrew the glass cover

inside the drum.

 Replace the faulty bulb with a new one and screw

the glass cover back on. Replacement bulb: 15W,

220/240 V, E14, suitable up to 300°C.

If, after carrying out the above checks the

malfunction persists or appears again, turn

the dryer off and call our After-Sales Service

(refer to guarantee).

Please specify:

 The nature of the fault.

 The dryer type and model.

 The service code (the number after the word

Service on the adhesive rating plate) on the

right-hand side when the door is open.

 Your full address and phone number.

PREPARING THE LAUNDRY

INSIDE LIGHT

CHILD SAFETY LOCK

SELECTING A PROGRAMME AND OPTIONS

STARTING AND COMPLETING A PROGRAMME

CHANGING A PROGRAMME

INTERRUPTING A PROGRAMME

MAINTENANCE AND CLEANING

WATER CONTAINER TOP

INSTALLATION STABILITY

HEAT EXCHANGER

BUILT-IN INSTALLATION

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

Whirlpool awz quality Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool awz quality

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info