Bedienungsanleitung Whirlpool FFD10469EBV BE (Seite 4 von 4) (Englisch)

793708

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

TROUBLESHOOTING

The washing machine may sometimes not work properly for certain reasons. Before calling the Support Centre, it is recommended to check to see if

the problem can be easily resolved using the following list.

Anomalies: Possible causes / Solution:

The washing machine does not turn on. • The plug is not inserted into the electrical outlet, or not enough to make contact.

• There has been a power failure.

The wash cycle does not start.

• The door is not fully closed.

• The ON/OFF button has not been pressed.

• The START/PAUSE button has not been pressed.

• The water tap is not open.

• A “start delay” has been set.

The washing machine does not ll with

water (the message “NO WATER”, Turn

tap on” is shown on the display).

“Beep” sound every 5 seconds.

• The water intake hose is not connected to the tap.

• The hose is bent.

• The water tap is not open.

• The mains water supply has been shut o.

• There is not enough pressure.

• The START/PAUSE button has not been pressed.

The washing machine loads and drains

water continuously.

• The drain hose has not been installed at 65 to 100 cm from the ground.

• The end of the drain hose is immersed in water.

• The drain connector on the wall does not have an air vent.

If the problem persists after having performed these checks, close the water tap, shut o the

washing machine, and call the Support Centre.If the dwelling is located on one of the

uppermost oors of a building, a siphon eect can sometimes occur, thus causing the washing

machine to load and drain water continuously.Special anti-siphon valves are available on the

market to prevent these types of problems.

The washing machine does not drain or

does not spin.

• The programme does not include the draining function: with certain programmes it must be

activated manually.

• The drain hose is bent.

• The drain line is obstructed.

The washing machine vibrates

excessively during the spin cycle.

• At the time of installation, the drum was not properly unlocked.

• The washing machine is not level.

• The washing machine is squeezed between furniture and the wall.

The washing machine leaks water.

• The water intake hose has not been tightened properly.

• The detergent dispenser is clogged.

• The drain hose has not been properly fastened.

The machine is locked and the display

ashes, indicating an error code (e.g.

F-01, F-..).

• Shut o the machine, disconnect the plug from the outlet, and weight about 1 minute before

turning it back on.

If the problem persists, call the Support Centre.

Too much foam is formed.

• The detergent is not compatible with the washing machine (it must bear the wording “for

washing machines”, “ for hand washing and washing machines”, or something similar).

• The dosage was excessive.

Door is locked, with or without

failure indication, and the

programme does not run.

• Door is locked in case of power breakdown. Programme will continue automatically as soon as

the mains is available again.

• Washing machine is in a standstill. Programme will continue automatically after the origin of

the standstill does not persist anymore.

400011574092

You can download the H&S INSTRUCTIONS, PRODUCT FICHE and ENERGY DATA by:

• Visiting our website - http://docs.whirlpool.eu

• Using QR code

• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting

our After-sales Service, please state the codes provided on your product’s identication plate.

For User’s Repair & Maintenance Information visit www.whirlpool.eu

The model information can be retrieved using the QR-Code reported in the energy label. The label also includes

the model identier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu

xxxxxxxxxxxx xxxx

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool FFD10469EBV BE Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool FFD10469EBV BE

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info