Bedienungsanleitung Whirlpool FWDD1071682WSVEUN (Seite 5 von 8) (Englisch)

756833

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Sort your laundry according to

Type of fabric/care label (cotton, mixed bres, synthetics, wool,

handwash items). Colour (separate coloured and white items, wash

new coloured items separately). Delicates (wash small items – like

nylon stockings – and items with hooks – like bras – in a cloth bag or

pillow case with zip).

Empty all pockets

Objects like coins or lighters can damage your laundry as well as the

drum.

Follow the dosage recommendation / additives

It optimizes the cleaning result, it avoids irritating residues of surplus

detergent in your laundry and it saves money by avoiding waste of

surplus detergent

Use low temperature and longer duration

The most ecient programmes in terms of energy consumption

are generally those that perform at lower temperatures and longer

duration.

Observe the load sizes

Load your WASHER DRYER up to the capacity indicated in the

“PROGRAMME CHART” table to save water and energy.

Noise and remaining moisture content

They are inuenced by the spinning speed: the higher the spinning

speed in the spinning phase, the higher the noise and the lower the

remaining moisture content.

WASH SYMBOLS ON GARMENT LABELS

The value given in the tub symbol is the maximum temperature

possible for washing the garment.

Normal mechanical action

Reduced mechanical action

Much reduced mechanical action

Hand wash only

Do not wash

CLEANING & MAINTENANCE

For any cleaning and maintenance, switch o and unplug the washer

dryer. Do not use ammable uids to clean the washer dryer.

Clean and maintain your washer dryer periodically (at least 4 times per

year).

Cleaning the outside of the WASHER DRYER

Use a soft damp cloth to clean the outer parts of the washer dryer.

Do not use glass or general purpose cleaners, scouring powder or

similar to clean the control panel – these substances might damage

the printing

Checking the water supply hose

Check the inlet hose regularly for brittleness and cracks. If damaged,

replace it by a new hose available through our After-Sales Service or

your specialist dealer. Depending on the hose type:

If the inlet hose has a transparent coating, periodically check if the

colour intensies locally. If yes, the hose may have a leak and should

be replaced.

Cleaning the water lter / draining residual water

If you used a hot wash programme, wait until the water has cooled down

before draining any water. Clean the water lter regularly, to avoid that

the water cannot drain after the wash due to obstruction of the lter.

Remove the plinth by using the removable plastic partition of the

detergent dispenser: push downwards one side of the plinth with

your hand, then push the removable plastic partition into the gap

between plinth and front panel and pry open the plinth. Place a

broad, at container beneath the water lter, to collect the drain

water. Slowly turn the lter counterclockwise until water ows

out. Let the water ow out, without removing the lter. When the

container is full, close the water lter by turning it in clockwise.

Empty the container. Repeat this procedure until all the water has

drained. Lay a cotton cloth beneath the water lter, which can

absorb a small amount of rest water. Then remove the water lter

by turning it out anti clockwise. Clean the water lter: remove

residues in the lter and clean it under running water. Insert the

water lter and reinstall the plinth: Reinsert the water lter again

by turning it in clockwise direction. Make sure to turn it in as far as

it goes; the lter handle must be in vertical position. To test water

tightness of the water lter, you can pour about 1 liter of water into

the detergent dispenser. Then reinstall the plinth.

Cleaning the detergent dispenser

Remove the detergent dispenser by pressing on the release button

and at the same time pulling out the detergent dispenser. Remove

the insert from the detergent dispenser, as well as the insert of

the softener compartment. Clean all parts under running water,

removing all detergent or softener residues. Wipe the parts dry

with a soft cloth. Reinstall the detergent dispenser and push it back

into the detergent compartment.

SAVING ENERGY AND PROTECTING THE

ENVIRONMENT

• Keeping within the load limits indicated in the programme

chart will optimise energy, water and detergent consumption

and reduce washing times.

• Do not exceed the detergent quantities recommended by the

detergent manufacturer.

• Save energy by using a 60°C instead of a 90°C wash

programme, or by using a 40°C instead of a 60°C wash

programme. We recommend using the programme for

cotton garments, which is longer but uses less energy.

• To save energy and time when washing and drying, select

highest spin speed available for the programme to reduce the

residual water remaining in the garments at the end of the

wash cycle.

HINTS AND TIPS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool FWDD1071682WSVEUN Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool FWDD1071682WSVEUN

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info