Bedienungsanleitung Whirlpool grand prix c0 (Seite 2 von 2) (Englisch)

301945

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 307 00327

1. Check that all fastenings are closed and that

pockets are empty.

2. Turn the articles inside out.

3. Place laundry loosely in the drum to make

sure it doesn’t become tangled.

Sort laundry as follows:

A) By care symbols (on the collar or inside

seam):

Suitable for tumble drying

Tumble drying with reduced drying

intensity only

Do not tumble dry

B) By amount and thickness/weight

Whenever the load to be dried exceeds dryer

capacity, separate laundry according to

weight (e.g. towels from thin underwear).

C) By type of fabrics

Cotton/linen

: Towels, cotton jersey, bed

and table linen made of cotton or linen.

Synthetics/Easy Care

: Blouses, shirts,

overalls, etc. made of polyester or polyamide,

as well as cotton/synthetic mixes.

D) By drying level

• Sort into: iron dry, cupboard dry, etc.

Do not tumble dry:

Woollens, silk, nylon

stockings, delicate embroidery, fabrics with

metallic decorations, bulky items such as

sleeping bags, etc.

Important: only use specific indicated dryer-

safe additives

and rinse items that have been

treated with stain remover thoroughly in plenty

of water before drying.

Only use specific

indicated dryer-safe plastic items

and never

dry rubber or articles contaminated with

vegetable oil in the dryer

Programme and Options:

• To select a programme, turn the programme

selector knob to the required position. The

Start/Pause indicator lamp is blinking,

“ “ indicating that the cycle needs to be

started.

• To select an option, press the corresponding

button. The indicator light in the button

lights up confirming that the selection has

been made.

• Press the option button again to cancel the

option.

1. Having selected the desired programme and

options, press the Start/Pause button.

If the laundry is not removed at the end of

the drying cycle, an automatic anti-crease

cycle will operate for maximum 60 min. The

drum rotates at regular intervals, preventing

the laundry from creasing.

This Anti-Crease cycle can be extended up

to 12h when Anti-Crease option has been

selected.

On completion of the programme, set the

programme selector knob to position

“0”

When changing the programme during the

drying cycle, the dryer stops. The Start/Pause

indicator lamp is blinking “ “.

To operate the new programme, press the

Start/Pause button.

To interrupt the dryer during operation

1. Set the programme selector knob to Airing.

2. Press the Start/Pause button.

Wait at least 5 minutes before opening the

door to allow the dryer to cool down.

For your safety the programme stops

automatically if you open the door.

To restart, after door opening, close the door

and press the Start/Pause button again.

Clean the lint filter at the end of every drying

cycle:

1. Open the door.

2. Pull the filter upwards.

3. Open the filter.

4. Remove lint using a soft brush or your

fingertips.

5. Close the filter.

6. Push the filter back into place

Empty the water container at the end of every

drying cycle.

1. Pull the handle to remove the water container.

2. Empty the water container.

3. Replace the water container when empty by

pushing it

completely

back in place.

The 6 kg cotton programmes are made for

matching a 6 kg washed load of cotton spun at

more than 1000 rpm. With a 6 kg load spun at

lower speed than 1000 rpm, we recommend to

connect your dryer to an external drainage hose

for direct water drainage to avoid water

container emptying.

This is also valid for testing according the

standard IEC/EN 61121

If a fault occurs, before contacting our After-

Sales Service, make the following checks to

try and remedy the problem:

Drying takes too long / laundry is not dry enough:

• Was the correct programme selected?

• Was the inserted laundry too wet?

• Is the lint filter dirty (filter indicator lamp on)?

• Is the heat exchanger dirty? (refer to the

Instructions for use)

• Is the ambient temperature too high?

The dryer does not operate:

(after a power failure and/or interruption to

the mains supply, always press the Start/

Pause button).

• Is the plug properly inserted into the mains

electricity socket?

• Is there a power failure?

• Has the fuse blown?

• Is the door properly closed?

• Has the programme been selected?

• Has the

Start/Pause

button been pressed?

Lint filter or water container indicator lamp

light on:

• Is the lint filter clean?

• Is the water container empty?

• Is the water container correctly positioned?

• Is the heat exchanger clean?

Water droplets underneath the dryer:

• Is the heat exchanger correctly positioned?

• Has any fluff on the heat exchanger seal

been wiped away?

• Has any fluff on the door seal been wiped away?

• Has the water container been positioned

correctly?

All programme sequence indicators blinking:

• Service call necessary.

If, after carrying out the above checks the

malfunction persists or appears again, turn the

dryer off and call our After-Sales Service (refer to

guarantee).

Please specify:

• The nature of the fault.

• The dryer type and model.

• The service code (the number after the word

Service on the adhesive rating plate) on the

right-hand side when the door is open.

• Your full address and phone number.

PREPARING THE LAUNDRY SELECTING A PROGRAMME & OPTIONS

STARTING & COMPLETING A PROGRAMME

CHANGING A PROGRAMME

INTERRUPTING A PROGRAMME

DAILY MAINTENANCE & CLEANING

DRAINAGE SYSTEM

TROUBLESHOOTING GUIDE

AFTER-SALES SERVICE

Whirlpool grand prix c0 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool grand prix c0

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info