Bedienungsanleitung Whirlpool HSCX 10441 (Seite 7 von 8) (Englisch)

650774

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

controlled via 6th Sense Live app.

• If you start a programme remotely, at the end of the programme

the dryer will automatically exit the Remote Control mode and will

switch o.

To manually exit Remote Control:

• With the machine in Remote Control, press again the Remote

Control button. You will regain local control over the control panel

of the dryer.

Key lock

To lock keys of the control panel against unwanted operation.

To lock the keys:

• The dryer must be switched on.

• Press and hold the Options button until the display

indicates that the keys are locked. Buttons and keys are

locked now. Only the On/O button works

• If you switch the dryer o and on again, the key lock

remains active until you unlock it.

To unlock the keys:

• Press and hold the Options button until the display indicates that

the keys are unlocked.

INDICATORS

Connection status

If your dryer has been already connected to the Internet (see 6th

Sense Live Remote Control / Setup Procedure section in the Use and

Care Guide) this indicator provides a feedback about the status of

the Internet connection through your WiFi router.

When you switch on the dryer, the connection status indicator

blinks: the dryer is looking for a connection.

When it becomes solidly lit, it means that the dryer is properly

connected to the Internet.

The strength of the wireless signal is shown by the indicator (when

all the elements of the indicator are lit, the signal strength is strong).

Failure

For any failures, refer to section TROUBLESHOOTING in the USE AND

CARE GUIDE.

Energy monitor

Gives feedback about the energy consumption of the programme

setting.

The less indicators light up, the more economic is your programme

setting.

CARE AND MAINTENANCE

Switch off and unplug the dryer before doing any cleaning and maintenance.

Caution, the water in the water tank can still be hot.

• Empty water tank after each drying cycle

Hold the handle and carefully pull out the water tank. Hold the

full water tank with both hands. Empty the water and insert the

container by pushing it back into place. Make sure that it is properly

inserted.

• Clean door lter after each drying cycle

Open the door and remove the door lter by pulling it upwards.

Press the button to open the door lter. Remove the lint inside.

Close the lter and reinsert it in the right direction, so that it

completely integrates in the lter chamber.

• Clean the bottom lter after about every fth drying cycle

Open the bottom ap. Hold the handle and pull out the bottom

lter.

Remove the foam from the bottom lter, to clean it. Clean the lter

foam and the lter by hand or under running water. Do not wash the

lter foam in the washing machine. Wring out the lter foam. Do not

insert it in the bottom lter dripping wet.

Fix the lter foam on the bottom lter. Clean the lter chamber of

the dryer with a damp cloth or carefully with a vacuum cleaner.

Insert the bottom lter again. Clap the lter handle down and close

the bottom ap.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool HSCX 10441 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool HSCX 10441

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info