Bedienungsanleitung Whirlpool Indiana C (Seite 2 von 9) (Englisch)

69111

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

SAFETY ADVICES BEFORE USING THE

DRYER / CONNECTIONS

1. Removing the packaging and check

•

After unpacking, make sure that the dryer is

undamaged. If in doubt, do not use the dryer.

Contact After-Sales Service or your local retailer.

•

If the appliance was exposed to the cold prior to

delivery, keep it at room temperature for a few

hours before operating.

•

Keep the packaging materials (plastic bags,

polystyrene parts, etc.) out of reach of children, as

they are potentially dangerous.

•

Remove the protective foil from the control panel.

2. Electrical Connections

•

Electrical connections must be carried out by a

qualified technician in compliance with the

manufacturer’s instructions and current standard

safety regulations.

•

Electrical connection must comply with local

Electricity Board regulations.

•

Voltage information, power consumption and the

required fuse protection is shown on the rating

plate mounted at the rear of the dryer.

•

The manufacturer cannot accept any liability for

personal injury or damage to property resulting

from failure to adhere to these instructions.

•

The dryer must be earthed as prescribed by law.

•

Do not use extension leads or multiple adaptors.

•

Before any maintenance on the dryer disconnect it

from the mains supply.

•

Do not operate the dryer if it has been damaged

during transport. Contact one of our After-Sales

Service technicians.

•

Mains cable replacement is only to be carried out by

After-Sales Service.

•

After installation access to the mains plug has to be

guaranteed, or the all-pole disconnection has to be

possible with a switch.

3. Installation

•

Do not install your dryer where it can be subject to

extreme conditions, such as: poor ventilation,

temperatures below 5°C or above 35°C.

•

Before running the first cycle ensure the water

container and heat exchanger are correctly positioned.

•

Only for water container top version: if possible use

a hose to drain the water directly into the domestic

plumbing system. This will avoid having to empty

the water container at the end of each drying cycle

since the condensation water can be directly

drained away. See also chapter “Drainage System”.

•

Take care not to install the dryer on a deep-pile

carpet.

•

Take care not to trap the mains cable between the

dryer and the wall.

Stability:

When installing the dryer always carefully level the

dryer adjusting the four feet and check the correct

levelling with a spirit level.

To built in the dryer

Remove the work-top and replace it with the Built-

In kit (according to Eec Electrical Regulations),

available at your dealer. As prescribed by law, only

a qualified technician has to do the installation.

Stacking kit

Depending on the model, your dryer can be

stacked on top of your front loading washing

machine. Please contact your dealer or our

After-Sales Service.

Minimum housing dimensions:

Width: 600 mm

Height: 855 mm

Depth: 600 mm

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool Indiana C Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool Indiana C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info