Bedienungsanleitung Whirlpool magic 1000 (Seite 2 von 2) (Englisch)

304248

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 301 05395

Whirlpool is a registered trademark of Whirlpool USA.

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized

conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in

the table in relation to the water supply pressure and temperature, the load and the type of wash.

Add the detergents as described in the programme

table or in the chapter “Detergents and Additives” in

the booklet.

1. Open the tap.

2. Set the

programme selector

to the desired

programme.

3. Set the

temperature selector

to the desired

temperature.

Special options

can be selected.

5. Check that the door is well closed and turn on the

washing machine by pressing the

“ON/OFF”

button. The indicator lights up, indicating that

the washing machine is on.

“Half Load” button

• Reduces water consumption, above all during rinsing.

• Suitable for lightly-soiled laundry and small loads

(max 3 kg).

Note:

Reduce the detergent quantity.

“Intensive Rinse” button

• More water and a longer time in rinse cycle is

added.

• This option is particularly suitable for areas with

very soft water, washing baby linen and helps

people with allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water

without progressing to the final spin cycle to

avoid creasing and prevent colours from

changing.

• This option is particularly recommended for the

programme “Synthetics”, “Daily” and “Delicates”.

• This function is particularly useful if you want to

postpone spinning to a later time, or if you want

to drain only.

CONSUMPTION DATA

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx.

Programme

Duration

(hours:minutes)

Cotton 90 5.0 49 1.70 2:00

Cotton 60 5.0 44 0.95 2:00

Cotton 40 5.0 44 0.60 2:05

Daily 40 3.0 47 0.48 1:00

Synthetics 60 2.5 55 0.80 1:30

Synthetics 40 2.5 55 0.60 1:20

Delicates 40 1.5 60 0.60 0:45

Wool 40 1.0 60 0.45 0:40

Silk 30 1.0 60 0.30 0:40

ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE

PROGRAMME

SELECT ANY DESIDERED OPTION

Terminate the “Rinse Hold” option:

• Press the “Rinse Hold” button again; the

programme will terminate automatically with

the final spin cycle for the present wash

programme.

If you do not wish to spin the clothes, turn the

programme selector knob to the “Drain”

programme.

“Spin Speed Reduction” button

• Reduces the predetermined automatic

maximum spin speed.

In some programmes the maximum final spin

speed is limited to go easy on your laundry

items. Selection of a higher spin speed is not

possible.

To reselect a programme when a cycle has already

begun:

1. Switch off the appliance by pressing the “

ON/

OFF

” button.

2. Select the new programme.

3. Start the programme by pressing the “

ON/OFF

”

button.

1. At the end of the programme the programme

selector moves to the stop position.

2. To unload the machine wait for the door to

unlock (about 1 minute).

3. Switch off the appliance, open the door and

take out the laundry.

4. Close the tap and leave the door ajar to allow

the drum to dry out.

•

WATER LEVEL

It may not be visible as the cycle is optimised

for a minimum water consumption without

compromising washing results.

•

SPIN SPEED CONTROL

Spin speed may be reduced automatically or

may even be excluded in the case of small

loads with highly absorbent garments (e.g.

bathrobes, bathmat).

This control avoids cloth and machine damage

and excessive vibrations and consequent

noise produced by the machine due to load

unbalance: by selecting high spin speeds the

noise level increases.

•

MOTOR NOISE

The running noises of the new, electronically-

controlled motor are not the same as the ones

you are used to from your old appliance. Don’t

be surprised - modern technology has a

modern sound.

•

CLEANING THE FILTER

To ensure an impeccable function of the

pump, check the filter regular and clean it if

necessary.

PROGRAMME CHANGE

PROGRAMME END

NOTES AND INDICATIONS FOR USE

3gb05395.fm Page 2 Friday, July 12, 2002 6:10 PM

Black process 45.0° 100.0 LPI

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool magic 1000 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool magic 1000

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info