Bedienungsanleitung Whirlpool W7OM44S1H (Seite 13 von 17) (Englisch)

756882

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

CLEANING AND MAINTENANCE

Make sure that the oven has

cooled down before carrying out

any maintenance or cleaning.

Do not use steam cleaners.

Do not use wire wool, abrasive

scourers or abrasive/corrosive

cleaning agents, as these could

damage the surfaces of the

appliance.

Wear protective gloves.

The oven must be disconnected

from the mains before carrying

out any kind of maintenance work.

EXTERIOR SURFACES

•Clean the surfaces with a damp microfibre cloth.

If they are very dirty, add a few drops of pH-neutral

detergent. Finish off with a dry cloth.

•Do not use corrosive or abrasive detergents. If any

of these products inadvertently comes into contact

with the surfaces of the appliance, clean immediately

with a damp microfibre cloth.

INTERIOR SURFACES

•After every use, leave the oven to cool and then

clean it, preferably while it is still warm, to remove

any deposits or stains caused by food residues. To

dry any condensation that has formed as a result

of cooking foods with a high water content, let the

oven to cool completely and then wipe it with a cloth

or sponge.

•Activate the “Smart Clean” function for optimum

cleaning of the internal surfaces. (Only in some

models).

•Clean the glass in the door with a suitable liquid

detergent.

•The oven door can be removed to facilitate cleaning.

ACCESSORIES

Soak the accessories in a washing-up liquid solution

after use, handling them with oven gloves if they

are still hot. Food residues can be removed using a

washing-up brush or a sponge.

CLEANING THE CATALYTIC PANELS ONLY IN SOME MODELS

This oven could be equipped with special catalytic liners

that facilitate cleaning of the cooking compartment

thanks to their special self-cleaning coating, which is

highly porous and able to absorb grease and grime.

These panels are fitted to the shelf guides: When

repositioning and then refitting the shelf guides, make

sure that the hooks at the top are slotted into the

appropriate holes in the panels.

To make best use of the catalytic panels’ self-cleaning

properties, we recommend heating the oven to 200°C

for around one hour using the “Convection Bake”

function. The oven must be empty during this time.

Then leave the oven to cool down before removing any

remaining food residues using a non-abrasive sponge.

Please note: Using corrosive or abrasive cleaning agents, sti

brushes, pan scourers or oven sprays could damage the

catalytic surface and compromise its self-cleaning properties.

Please contact our After-sales Service if you require

replacement panels.

REPLACING THE LAMP

1. Disconnect the oven from the power supply.

2. Unscrew the cover from the light, replace the bulb

and screw the cover back on the light.

3. Reconnect the oven to the power supply.

Please note: Only use 20-40 W/230 ~ V type G9, T300°C

halogen bulbs. The bulb used in the product is specically

designed for domestic appliances and is not suitable for

general room lighting within the home (EC Regulation

244/2009). Light bulbs are available from our After-sales

Service.

- If using halogen bulbs, do not handle them with your bare

hands as your ngerprints could cause damage. Do not use

the oven until the light cover has been retted.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool W7OM44S1H Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool W7OM44S1H

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info