Bedienungsanleitung Whirlpool WHCN94 (Seite 5 von 18) (Englisch)

702411

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

EN5

INSTALLATION

After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your

nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at

the time of installation.

PREPARING FOR INSTALLATION

WARNING:

this is a heavy product; the hood should only be lifted and installed by two or more people.

The minimum distance between the support of the cooking pans on top of the cooker and the bottom of the hood must

not be less than 50 cm for electric cookers and 65 cm for gas or mixed cookers. Before installation also check the

minimum distances stated in the manual of the cooker.

If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be

observed.

ELECTRICAL CONNECTION

Make sure the power voltage specied on the appliance rating plate is the same as the mains voltage.

This information may be found on the inside of the hood, under the grease lter.

Power cable replacement (type H05 VV-F 3 x 0,75 mm²) must be carried out by a qualied electrician. Contact an

authorized service centre.

If the hood is tted with an electric plug, connect the plug to a socket complying with current regulations, located in an

accessible place after installation. If no plug is tted (direct wiring to the mains), or if the socket is not located in an

accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in

case of category III overvoltage conditions, in accordance with installation rules.

If the cable is not tted with a plug, connect the wires according to the following table:

Mains voltage

and frequency

Wire connection

220-240 V

50/60Hz

: yellow/green

N : blue

L : brown

FILTERING OR DUCTING ?

! Your cooker hood is ready to be used in suction version.

To use the hood in ltering version the special ACCESSORY KIT must be installed.

Check on the rst pages of this manual if the ACCESSORY KIT is furnished or must be bought separately.

Note: If furnished, in certain cases, the additional activated carbon ltering system may be installed on the hood.

Information about the conversion of the hood from suction version to ltering version is present in this manual.

Ducting version

In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection

ring located on top of the hood.

Attention! The exhausting pipe is not supplied and must be purchased apart.

Diameter of the exhausting pipe must be equal to that of the connection ring.

Attention! If the hood is supplied with active charcoal lter, then it must be removed.

Filter version

The aspirated air will be degreased and deodorised before being fed back into the room.

In order to use the hood in this version, you have to install a system of additional ltering based on activated charcoal.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WHCN94 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WHCN94

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info