Bedienungsanleitung Whirlpool WHE25352 F (Seite 1 von 6) (Englisch)

587333

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

INSTRUCTIONS FOR USE

APPLIANCE DIAGRAM (Fig. 1)

A. Handle.

B. Safety closure (if provided).

C. Seal.

D. Separator (if provided).

E. Defrost water drain plug.

F. Control panel.

G. Side motor ventilation grille.

CONTROL PANEL DIAGRAM (Fig. 2)

1. Red light: when blinking, it indicates an alarm condition

(see the section “TROUBLESHOOTING GUIDE”).

2. Blue light: when on, it indicates that the STOP FROST

function is activated (see the section “STOP FROST

FUNCTION”)

3. Green lights: they indicate that the product is working,

the set temperature and possible activation of the quick

freeze function (“Shopping”).

4. Setting button: for updating the set temperature,

activation/deactivation of the quick freeze function

(“Shopping”) and activation/deactivation of the “STOP

FROST” function.

BEFORE USING THE APPLIANCE

Your new appliance is designed to be used in the

household and similar applications such as:

- kitchen areas in shops, oces and other working

environments

- farm houses

- by clients in hotels, motels, residences, bed &

breakfasts.

The product must only be used to store frozen food, to

freeze fresh food and to make ice.

Regulations require the appliance to be earthed. The

manufacturer declines all liability for injury to persons

or animals and for damage to property resulting

from failure to observe the above procedures and

reminders.

1. After unpacking, make sure that the appliance is

undamaged and that the door closes perfectly, with the

gasket remaining intact. Any damage must be reported

to your retailer within 24 hours after delivery of the

appliance.

2. Wait at least two hours before switching the appliance on

in order to ensure the refrigerant circuit is fully ecient.

3. Installation and electrical connection must be carried out

by a qualied technician, according to the manufacturer’s

instructions and local safety regulations.

4. Clean the inside of the appliance before using it.

• Before connecting the appliance to the mains supply,

ensure that the voltage corresponds to that given on the

rating plate located on the rear of the appliance.

• Electricalconnectionsmustbemadeinaccordance

with local regulations.

INSTALLATION

• Unpacktheproduct.

• Removethe4spacersinsertedbetweenthelidand

the product. (Fig. 3)

• Make sure the defrost water drain plug (if provided) is

correctly positioned (E).

• For optimum operation and to avoid damage when the

lid is opened, maintain a distance of at least 7 cm from

the front wall and 7 cm at the sides. (Fig. 4)

• Insert the accessories (if provided).

STARTING THE PRODUCT

• Connect the product to the power supply.

• The green light (“Normal”) comes on.

• The red light (1) blinks, since the temperature inside the

product is not yet low enough for loading food. This light

normally goes o within six hours after startup.

• Place food inside only when the red light has gone o.

Note: If the STOP FROST function is deactivated, the lid

cannot be immediately reopened after closing it, because

the seal is tight. It is necessary to wait a few minutes before

reopening the lid.

TEMPERATURE ADJUSTMENT

Use the button (4) to select the required temperature. To

adjust the product temperature, proceed as follows:

• Press the button (4). With each press of the button, the

set temperature will be changed cyclically between the

values “Eco”, “Normal”, “Intensive” and “Shopping”.

• Select “Intensive” for a colder storage temperature.

• In case of a partial load, it is advisable to select “Eco” to

optimise energy consumption.

The green lights (3) indicate the selected setting as follows:

Eco: less cold temperature

(left light on).

Normal: middle temperature

(right light on).

Intensive: very cold temperature

(both lights on).

Shopping: Quick Freeze

(both lights on blinking).

See the section “Freezing fresh

food”.

Note: In case of a power failure, the settings (except for

the “STOP FROST” function) remain stored. The time

required for the temperature inside the freezer to reach

approximately the set value may vary depending on the

climatic conditions and the setting selected.

STOP FROST FUNCTION

The STOP FROST function signicantly reduces the

amount of frost that can form inside the product, collecting

it in the special easy to remove and clean “ICE BOX” (M)

container. STOP FROST technology also allows easy

reopening of the lid at any time whenever deemed

necessary, even repeatedly, always with the same eort.

The STOP FROST function is already activated when the

product is switched on the rst time (blue light on). It can be

deactivated/reactivated by keeping the button (4) pressed

for at least 3 seconds.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WHE25352 F Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WHE25352 F

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info