16
T1. ON/OFF “NIGHT LIGHT”
Press to switch the soft background lighting on or off.
T2. MAIN LIGHT ON/OFF – SELECT THE COLOUR TEMPERATURE
Press to switch the main light on or off.
With the lights on, swipe the SL1 LED strip with your finger to increase or decrease the light intensity (to the right or left respectively).
Press and hold to set the light colour temperature.
Swipe the SL1 LED strip with your finger to set a colder or warmer colour (to the right or left respectively).
If you do not change the colour for five seconds, SL1 will flash at the colour setting you have selected and an audible signal will
sound to indicate that the system has saved this configuration.
NB: the light will come on at the last colour temperature set before switching off the appliance.
T3. “AUTOLIGHT” FUNCTION
Press to activate/deactivate the “Autolight” automatic lighting function.
NB: this function is only activated when the hood is connected via wi-fi to the hob. Once the function has been activated,
the main light is automatically managed on the basis of the hob status.
T4. “ZEN MODE” FUNCTION
Press to activate or deactivate the "ZEN" extraction mode.
This function makes it possible to activate an extraction speed with the perfect balance between quietness and extraction efficiency.
T5. MOTOR ON/OFF
Press to switch the extraction motor on or off.
With the motor on, swipe the SL2 LED strip with your finger to increase or decrease the extraction speed (power) (to the
right or left respectively).
T6. “POWER BOOST 1” FUNCTION
With the extraction motor on, press T6 to activate the "POWER BOOST 1" intensive extraction speed (time-controlled).
NB: the hood will go back to its previous speed after five minutes.
T7. “POWER BOOST 2” FUNCTION
With the extraction motor on, press T7 to activate the "POWER BOOST 2" intensive extraction speed (time-controlled).
Please note: the hood will go back to running at the speed it was previously using after five minutes.
T8. AUTOMATIC “COOKSENSE” FUNCTION
The hood will automatically set an extraction speed of 1, and then increase it if necessary (according to the ambient conditions
detected by the hood sensor).
If the hood is using extraction speed 1 and there is no change in the ambient conditions, it will switch off after 5 minutes.
NB: to make sure this function is used correctly, please configure the parameters for automatic mode first as described in the
relevant section.
NB: if you change any other speed control functions while automatic mode is active, the auto ventilation function will switch off.
T9. FILTER SATURATION INDICATOR
At regular intervals, the hood signals the need to perform filter maintenance.
Please note: The indicators will only work when the hood is on.
T9 button lit: carry out maintenance on the grease filter.
T9 button flashing: carry out maintenance on the carbon filter.
Resetting the filter saturation indicators:
Please note: This must be done with the hood switched on.
Press and hold the T9 button. The light will switch off to confirm the reset.
Activating the carbon filter saturation indicator.
Please note: This must be done with the extraction motor switched off.
This indicator is normally deactivated. It should be activated if the hood is installed in the filtering version (i.e. with carbon
filters).
Press and hold buttons T1 and T10 simultaneously to activate the function. The buttons will light up to indicate activation.
To deactivate the function, press and hold the same buttons (T1 and T10) again. The buttons will flash briefly and then switch off to
indicate deactivation.
