Bedienungsanleitung Whirlpool WHVS90F (Seite 1 von 5) (Englisch)

702377

Zoom out

Zoom in

Vorherige Seite

1/5

Nächste Seite

Quick guide

THANK YOU FOR BUYING A WHIRLPOOL PRODUCT

In order to receive a more complete assistance, please

Before using the appliance carefully read the Safety

Instruction.

PRODUCT DESCRIPTION

FIRST TIME USE

AIR VENT (FOR THE SUCTION VERSIONS)

Connect the hood and discharge holes on the walls with a diameter

equivalent to the air outlet (connection ange).

Using the tubes and discharge holes on walls with smaller dimensions

will cause a diminution of the suction performance and a drastic

increase in noise.

Any responsibility in the matter is therefore declined.

! Use a duct of the minimum indispensable length.

! Use a duct with as few elbows as possible (maximum elbow angle: 90°).

! Avoid drastic changes in the duct cross-section.

! The company declines any responsibility whenever these regulations

are not respected.

FILTERING OR DUCTING?

! Your cooker hood is ready to be used in suction version.

To use the hood in ltering version the special ACCESSORY KIT must be

installed.

Check if the ACCESSORY KIT is furnished or must be bought separately.

Note: If furnished, in certain cases, the additional activated carbon ltering

system may be installed on the hood. Information about the conversion of

the hood from suction version to ltering version is present in the Manual

“Safety Instructions & Installation”.

DUCTING VERSION

In this case the fumes are conveyed outside of the building by means

of a special pipe connected with the connection ring located on top of

the hood.

Attention! The exhausting pipe is not supplied and must be purchased

apart. Diameter of the exhausting pipe must be equal to that of the

connection ring.

Attention! If the hood is supplied with active charcoal lter, then it

must be removed.

FILTER VERSION

The aspirated air will be degreased and deodorised before being fed

back into the room.

In order to use the hood in this version, you have to install a system of

additional ltering based on activated charcoal.

CONTROL PANEL

T1 T2 SL1 T4 SL2 T6T5 T7 T10T8 T9 T12T11

T3 T13

T1. ON/OFF “Night Light”

T2. Hob lights ON/OFF – Select the colour

temperature

T3. “Autolight” function

T4. “ZEN Mode” function

T5. Motor ON/OFF

T6. “POWER BOOST 1” function

T7. “POWER BOOST 2” function

T8. Automatic “COOKSENSE” function

T9. Filter saturation indicator

T10. ON/OFF “Breath Daily Cycle”

T11. ON/OFF “Breath Intensive Cycle"

T12. Light indicator for WI-FI function active

T13. WI-FI connection

T1. ON/OFF “NIGHT LIGHT”

Press to switch the soft background lighting on or o.

T2.

HOB LIGHTS ON/OFF  SELECT THE COLOUR TEMPERATURE

Press to switch the hob lights on or o.

• With the lights on, swipe the SL1 LED strip with your nger

to increase or decrease the light intensity (to the right or left

respectively).

Press and hold to set the light colour temperature.

• Swipe the SL1 LED strip with your nger to set a colder or warmer

colour (to the right or left respectively).

If you do not change the colour for ve seconds, SL1 will ash at

the colour setting you have selected and an audible signal will

sound to indicate that the system has saved this conguration.

NB: the light will come on at the last colour temperature set before

switching o the appliance.

T3. “AUTOLIGHT” FUNCTION

Press to activate/deactivate the “Autolight” automatic lighting

function.

NB: this function is only activated when the hood is connected via

wi- to the hob. Once the function has been activated, the hob light is

automatically managed on the basis of the hob status.

T4. “ZEN MODE” FUNCTION

Press to activate or deactivate the "ZEN" extraction mode.

This function makes it possible to activate an extraction speed with the

perfect balance between quietness and extraction eciency.

T5. MOTOR ON/OFF

Press to switch the extraction motor on or o.

• With the motor on, swipe the SL2 LED strip with your nger to

increase or decrease the extraction speed (power) (to the right or

left respectively).

T6. “POWER BOOST 1” FUNCTION

With the extraction motor on, press T6 to activate the "POWER BOOST

1" intensive extraction speed (time-controlled).

NB: the hood will go back to its previous speed after ve minutes.

T7. “POWER BOOST 2” FUNCTION

With the extraction motor on, press T7 to activate the "POWER BOOST

2" intensive extraction speed (time-controlled).

Please note: the hood will go back to running at the speed it was

previously using after ve minutes.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WHVS90F Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WHVS90F

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info