Bedienungsanleitung Whirlpool WQ9IFO1BX (Seite 26 von 40) (Englisch)

756838

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Dispensing

Touch the Ice keypad for your ice selection.

NOTES:

■For crushed ice, cubes are crushed before being

dispensed. This may cause a slight delay when

dispensing crushed ice. Noise from the ice crusher is

normal and pieces of ice may vary in size.

■When changing from crushed to cubed, a few ounces of

crushed ice will be dispensed along with the rst cubes.

Dispensing Water

IMPORTANT:

■Dispense at least 1 qt (1 L) of water every week to maintain

a fresh supply.

■If the ow of water from the dispenser decreases, it could

be caused by low water pressure.

■With the water lter removed, dispense 1 cup (237 mL)

of water. If 1 cup (237 mL) of water is dispensed in

8 seconds or less, the water pressure to the refrigerator

meets the minimum requirement.

■If it takes longer than 8 seconds to dispense 1 cup

(237 mL) of water, the water pressure to the refrigerator

is lower than recommended. See the “Water Supply

Requirements” and “Troubleshooting” sections for

suggestions.

To Dispense Water: Standard:

1. Press a sturdy glass against the water dispenser paddle.

2. Remove the glass to stop dispensing.

To Dispense Water - Measured Fill:

Measured Fill allows you to dispense a specied amount

of water with the touch of a few buttons.

1. Put a sturdy glass under water spout. Select the amount of

water and unit to dispense.

NOTE: The amount of water you select will be dispensed.

Make sure the container can hold the entire volume. If ice

is in the container, you may need to adjust your selection.

2. Touch DISPENSE or press paddle and the selected amount of

water will be dispensed.

NOTE: Most coffee cups (commonly 4 to 6 oz [118 to 177 mL]

per cup) are not the same size as a measuring cup (8 oz

[237 mL]). You may need to recalibrate Measured Fill to underll

or to avoid unintentionally overlling coffee cups.

3. Dispense water.

NOTE: While dispensing water, the ow of water will

automatically stop once the desired volume has been

dispensed.

■Press a sturdy glass against the dispenser paddle below

the water spout.

■Place the glass below the water spout and touch

DISPENSE for hands-free dispensing.

4. To pause dispensing before the selected volume has been

dispensed, press pause button on screen

NOTE: If you stop dispensing before the desired volume has

been dispensed, the display will turn off after 1 minute. If you

have not resumed by then, it will reset back to the original

amount.

Ice Maker and Storage Bin

IMPORTANT: To avoid low ice production and poor quality ice,

ush the water system before turning on the ice maker. See the

“Water Dispenser” section.

n Following installation, allow 24 hours to produce the rst

batch of ice. Discard the rst 3 batches of ice produced.

Allow 2 to 3 days to ll the ice storage bin.

n The quality of your ice will be only as good as the quality of

the water supplied to your ice maker. Avoid connecting the ice

maker to a softened water supply. Water softener chemicals

(such as salt) can damage parts of the ice maker lead to poor

quality ice. If a softened water supply cannot be avoided,

make sure the water softener is operating properly and is well-

maintained.

n If the ice in the storage bin clumps together, break up ice

using a plastic utensil and discard. Do not use anything sharp

to break up the ice. This can cause damage to the ice bin and

the dispenser mechanism.

n Do not store anything in the ice storage bin.

Style 1 - Ice Maker in the Refrigerator

The ice maker is located on the left door behind the bins. Ice

cubes are ejected into the ice storage bin located on the left-hand

refrigerator door.

Remove and Replace the Ice Storage Bin

To open the Ice Maker box, pull the ice maker door lever until the

door releases.

n Remove the ice storage bin by inserting your ngers into the

hole at the base of the bin and pulling the latch to release the

bin from the compartment. Lift the storage bin up and pull it

straight out.

n Replace the storage bin inside the ice compartment and push

down to make sure it is rmly in place.

Ice Production Rate

n Your ice maker should produce approximately 3.5 lbs (1.6 kg)

of ice per day under normal operation.

Turn the Ice Maker On/Off

n To Turn on your Ice Maker, navigate to the Ice maker section

under Tools/Setup.

n To Turn off your Ice Maker, navigate to the Ice maker section

under Tools/Setup.

NOTES:

n Your ice maker has an automatic shutoff. The sensor will

automatically stop ice production if the storage bin is full or

the door is open. The control will remain in the On position.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WQ9IFO1BX Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WQ9IFO1BX

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info