Bedienungsanleitung Whirlpool WTLS 60912 ZEN - 6TH SENSE 1200 (Seite 2 von 2) (Englisch)

574740

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

5019 300 00055

CONSUMPTION DATA

Whirlpool is a registered trademark of Whirlpool USA.

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with

respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer

to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data.

The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also

“Troubleshooting Guide” in your Instructions for Use).

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

** Standard Cotton programme and basis for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.

Programme

Tempe-

rature

(°C)

Load

(kg)

Water

(l)

Energy

without “Rapid”

(kWh)

Approx. Programme Duration (hrs : min)

without “Rapid” with “Rapid”

Mixed 40 3.0 45 0.43 1:00 –

Cotton 95 6.0 55* 1.85 2:05 1:55

Cotton 60 6.0 48 1.02 2:30 1:45

Cotton 40 6.0 48 0.60 2:30 1:30

Synthetics 60 3.0 54* 0.85 1:55 1:14

Synthetics 40 3.0 50 0.50 1:40 0:59

Delicates 40 1.5 50 0.55 0:45 –

Wool/Handwash 40 1.0 40 0.55 0:35 –

Jeans 40 4.0 41 0.58 1:30 1:10

White 40 6.0 48 0.65 2:45 –

Light colours 40 4.0 67 0.50 1:20 1:00

Dark 40 4.0 41 0.58 1:40 1:10

Overnight 60 6.0 48 0.78 4:00 –

Aqua Eco 40 2.5 19 0.43 1:00 –

Speed 15´ 30 3.0 30 0.15 0:15 –

eCotton** 60 6.0 48 0.67 3:30 –

eCotton** 60 3.0 34 0.56 2:30 –

eCotton 40 6.0 48 0.61 3:15 –

eCotton** 40 3.0 34 0.47 2:30 –

Power consumption in off-mode 0.11 W / in left-on mode 0.11 W

ADD DETERGENTS, CLOSE THE LID AND

SELECT THE PROGRAMME

“LID OPEN” INDICATION

Before starting and after end of a programme, the lamp lights to

show the the lid can be opened. As long as a wash programme is

running, the lid remains locked and must on no account be forced

open. In case you have an urgent need to open it during a running

programme, refer to “Cancel a running programme before the end”.

“Spin” button (incl. “Rinse hold”)

• Every programme has a predefined spin speed.

• Press the button to set another spin speed.

• If you select spin speed “0”, the final spinning is cancelled and

the water is drained out only. However, intermediate spin

phases remain during the rinse.

• If you select “Rinse hold”, the laundry remains in the last rinse

water without progressing to the final spin cycle, to avoid

creasing and prevent colours from changing. To activate the

“Rinse hold”, press the “Spin” button repeatedly until the

“Rinse hold” symbol on the display lights up.

- The wash programme stops to “Rinse hold” when the

“Rinse hold” symbol on the display blinks; the light of

“Start(Pause)” button also blinks.

- To terminate the “Rinse hold” by spinning the laundry, press

“Start(Pause)” - the laundry will be spun with the default

spin speed. You can also select another spin speed with the

“Spin” button before you start the spin cycle by pressing

“Start(Pause)”.

- To terminate the “Rinse hold” by draining the water without

spinning, press the “Spin” button until spin speed “0” appears

on the display; then press “Start(Pause)” to start the

draining. Do not leave the laundry to soak for too long in the

“Rinse hodl” (especially silk).

“Colours 15° ” button

• Saves energy used for water heating while maintaining a good

wash result.

• Supports colour maintenance when washing coloured laundry.

• Recommendable for lightly soiled laundry without stains.

• Make sure that your detergent is suitable for cold wash

temperatures.

• Not selectable for Cotton 70 - 95°C.

“Rapid” button

• Enables quicker washing by shortening the programme duration.

• Recommendable for small loads or only lightly soiled laundry.

PROGRAMME START

ECO MONITOR

Open the tap and press the “Start(Pause)” button. The

indication lamp next to the “Start(Pause)” button lights up.

The display shows the remaining programme time. Due to

The “Eco monitor” gives you a rough feedback about the power

consumption of the programme setting you selected. As soon as

you turn the programme selector to any programme, the “Eco

monitor” is on.

The indicator on the left is to show that the “Eco monitor”

is active. The four indicators next to it show the degree of

consumption: the less power your programme setting is

forecasted to consume, the less indicators will light up. This

depends on the programme, temperature and options selected,

and also on the size of the wash load. For that reason, the

forecasted degree of power consumption may adapt when the

washing machine detects the wash load.

PROGRAMME END

• The “Door open” indication lights up. After about a quarter

of an hour, the washing machine will switch off completely to

save energy.

1. Turn the programme selector to the “Off/O” position.

2. Close the water tap.

3. Open lid and drum and unload the machine.

4. Leave the lid open for some time to allow the interior of the

machine to dry.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

1. Press the “Start(Pause)” button to pause the programme.

The light blinks.

2. Select the new programme, temperature, any options and

another spin speed if you want.

3. Press the “Start(Pause)” button again. The new programme

continues at the same position where the previous programme

was interrupted. Do not add detergent for this programme.

CANCEL A RUNNING PROGRAMME BEFORE

THE END

The “Reset/Drain” button cancels a programme before the end.

• Press the “Reset/Drain” button for at least 3 seconds. The

water is drained out; it may last a while until you can open the lid.

SELECT ANY DESIRED OPTION

When the combination of programme and additional option(s)

is not possible, the indication lights switch off automatically.

Unsuitable combinations of options are deselected automatically.

“Prewash” button

• Only for heavily soiled loads (for example sand, granular dirt).

Increases the cycle time by approximately 15 min.

• Do not use liquid detergent for the main wash when activating

the Prewash option.

“Intensive rinse” button

• More water is added and rinse cycle is prolonged.

• This option is particularly suitable for areas with very soft

water, washing baby linen and helping people with allergies.

“Soil level” button

• Adapts the programme duration to the soil level of your

laundry. Also influences the detergent quantity.

= lightly soiled - = normaly soiled - = heavily soiled

Not all soil levels are selectable for each programme.

FINISH ON TIME

With this function you can postpone your programme to

complete at a later time: press the button to select in how many

hours the programme shall be finished. Thus, it allows you to

have your laundry ready at a particular time and to profit from

more favourable energy rates during the night, for example.

• Do not use liquid detergent when activating this function.

• The time until the cycle end can be selected in full hour time

segments (1 to 24 h). When you press the button, the shortest

possible time will be displayed; keep on pressing the button to

loop through all the available times. To remove it again, keep

on pressing the button until you see the value “0:00”.

• When you have selected the desired time until the cycle end,

press “Start(Pause)” - the countdown will begin.

• During the countdown, you can still modify the programme

setting (select or deselect options, change spin speed etc.).

If the modifications prolong the programme duration so that

it overruns the originally set time until the cycle end, the

programme will start immediately.

• Sometimes the programme may finish before the selected

time until the cycle end has expired (e.g. for small loads).

In this case, the washing machine will tumble the laundry

regularly to keep it fresh, until the selected cycle end time

has expired. During tumbling, the display will show an

animation. The tumbling phase can be stopped at any time

either by pressing any button or by rotating the programme

selector; the animation will stop and the door will unlock in

about 1 minute as indicated on the display.

FAILURE INDICATIONS

DETERGENT OVERDOSAGE INDICATION

In case of any failures or irregularities, consult the

“Troubleshooting Guide” in your Instructions for Use.

“Water tap closed” -

No or not sufficient inlet water.

“Service” -

Failure or malfunction of an electrical component.

“Clean pump” -

Waste water is not pumped out.

Spin speed on display blinks: unbalance during spinning

The symbol will light up at the end of the programme if you

used too much detergent. use less detergent next time. If the

symbol lights up and the display shows “Fod”, too much foam

interrupted the wash process; refer to the “Troubleshooting

Guide” in your Instructions for use.

If there is a programme setting which you use frequently, the

appliance offers the possibility to save one setting for each

programme so that it can be used again by just pushing one button.

• Select the desired programme, temperature, spin speed and

option(s), push and hold the “Favourites” button for at least

3 seconds. The lamp next to “Favourites” shortly flashes

and then lights up - the programme settings is saved.

Next time you want to use your individual programme settings,

select the programme, push the “Favourites” button and start

by pushing “Start(Pause)”.

If you want to replace the saved programme setting by

another one:

• Select programme temperature, spin speed and options as

desired and then press and hold the “Favourites” button for

at least 3 seconds.The previously saved programme setting

will be replaced by the new one.

SAVE YOUR FAVOURITE PROGRAMMES

CHILD LOCK BUTTONS

You can lock the buttons of the control panel against improper

use (e.g. by children).

• Press both of the child lock buttons simultaneously and hold

them for at least 3 seconds. The key symbol on the display

lights up.

• To unlock the buttons again: proceed in the same way.

1. Load the machine, close the drum doors and check that they

are properly locked.

2. Add detergent and eventual additives as described on the

front page and in your Instructions for Use.

3. Close the lid.

4. Turn the programme selector to the desired programme

and temperature. The lamp next to the “Start(Pause)”

button blinks. The temperature can be altered by pressing

the “Temperature” button. If you do not start the programe

soon after having made your choice, the washing machine

will switch off automatically after about a quarter of an

hour. Switch on the washing machine again by turning the

programe selector back to „Off/O“ and then to the desired

programe.

variations in load and temperature of inlet water, the remaining

time is newly calculated in certain programme phases. If this is

the case, an animation appears on the time display.

Whirlpool WTLS 60912 ZEN - 6TH SENSE 1200 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WTLS 60912 ZEN - 6TH SENSE 1200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info