Bedienungsanleitung Whirlpool WVS93F (Seite 2 von 3) (Englisch)

702380

Zoom out

Zoom in

Vorherige Seite

1/3

Nächste Seite

T5. NIGHT LIGHT AMBIENT LIGHT

Press to switch the soft background lighting on or o.

T6. MAIN LIGHT OFF / DECREASE INTENSITY

Press to decrease intensity and to switch OFF light.

Press and hold to directly switch OFF.

T7. MAIN LIGHT ON / INCREASE INTENSITY

Press to switch ON and to increase light intensity.

Press and hold to directly switch ON.

TECHNICAL DATA

Height (cm) Width (cm) Depth (cm) Ø of exhaust tube (cm)

105 -148.6 89.8 36.9 15 - 12.5 - 12

CLEANING AND MAINTENANCE

CLEANING

• Do not use steam-cleaning equipment.

• Disconnect the appliance from the mains.

Important: do not use corrosive or abrasive detergents. If any such

products unintentionally come into contact with the appliance, clean

the appliance immediately with a damp cloth. Do not use alcohol.

• Clean the surfaces with a damp cloth. If it is very dirty, add a few

drops of washing-up detergent to the water. Finish o with a dry

cloth.

Important: do not use abrasive sponges or metallic scrapers or

scourers. Over time, these can ruin the enamel surfaces.

• Use detergents specically designed for cleaning the appliance

and follow the manufacturer's instructions.

Important: clean the lters at least once a month to remove oil and

grease residue.

MAINTENANCE OF THE GREASE FILTERS

This must be cleaned once a month (or when the lter saturation

indication system - if envisaged on the model in possession - indicates

this necessity) using non aggressive detergents, either by hand or in the

dishwasher, which must be set to a low temperature and a short cycle.

When washed in a dishwasher, the grease lter may discolour slightly,

but this does not aect its ltering capacity.

Open the extractor panel (turn upwards).

Please note: It is not necessary to remove the panel.

Pull out the handle to remove the lter.

Once the lter has been washed and left to dry, proceed in reverse

order to ret the lter.

MAINTENANCE OF THE CHARCOAL FILTER FOR FILTRATION

MODELS ONLY

This lter retains the unpleasant odours produced during cooking.

Replace the carbon lter every 4 months.

Fitting or replacing the carbon lter

1. Disconnect the hood from the mains.

2. Open and remove the extractor panel from its housing.

3. Remove the grease lters.

4. Fit one carbon lter on each side, covering both protective grilles

for the motor impeller.

Turn the lters clockwise to secure them to the central pins.

Proceed in reverse order to remove.

Ret the grease lters and extractor panel.

REPLACING THE LAMPS

The hood is equipped with an LED lighting system.

LEDs ensure excellent illumination, have a service life up to 10 times

longer than traditional bulbs, and oer up to 90% energy savings.

Note: For replacement LED, please contact the Technical After-sales Service

Centre.

* Available only on certain models

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool WVS93F Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool WVS93F

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info