Bedienungsanleitung Whirlpool ZEN TDLR724 (Seite 8 von 12) (Englisch)

756770

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

EN 7

CLEANING THE FILTER/ DRAINING RESIDUAL WATER

The washing machine is provided with a self-cleaning

pump. The ﬁlter keeps objects like buttons, coins,

safetypins etc. which have been left in the laundry.

We recommend to check and clean the ﬁlter regularly,

at least two or three times a year.

Especially:

• if the appliance is not draining properly or if it fails

to perform spin cycles.

• if the “Pump” indication lights up.

IMPORTANT: make sure the water has cooled

before draining the appliance.

Residual water must be drained also before transport-

ing the machine.

1. Unplug the washing machine.

2. Open the ﬁlter cover with a coin (picture 18).

3. Place a bowl beneath it.

4. Turn the ﬁlter slowly anti-clockwise until some

water starts to ﬂow out; do not remove it as yet.

5. Wait until all the water has drained.

6. Now unscrew the ﬁlter completely and extract it

(picture 19).

7. Clean the ﬁlter and the ﬁlter chamber.

8. Make sure the pump impeller (in the housing

behind the ﬁlter) is not obstructed.

9. Insert the ﬁlter again and screw it in

completely in clockwise direction. Make

sure the ﬁlter is screwed in properly, as far

as it will go.

10. Pour approximately one litre of water into the

washing machine via the drum and check that

water does not leak from the ﬁlter.

11. Close the ﬁlter cover.

12. Reconnect the washing machine.

CARE AND MAINTENANCE

Always unplug the washing machine before doing any maintenance.

Detergent dispenser

Clean the detergent dispenser regularly, at least

three or four times a year, to prevent detergent

build-up:

1. Press the button to release the detergent dispenser

and remove it (picture 20). A small quantity of

water can remain in the dispenser, thus you should

carry it in an upright position.

2. Wash the dispenser using running water. You can

also remove the siphon cap on the back of the

dispenser for cleaning (picture 21).

3. Replace the siphon cap in the dispenser (if

removed)

4. Reinstall the dispenser by locating the dispenser’s

bottom tabs into the appropriate openings on the

lid, and by pushing the dispenser against the lid

until it locks into place.

Make sure that the detergent dispenser is

correctly reinstalled.

Water inlet hose ﬁlter

Check and clean regularly (at least two or three

times a year).

1. Unplug the washing machine.

2. Turn off the tap.

3. Unscrew the hose from the tap.

4. Carefully clean the ﬁlter located at the end of hose,

without disassembling it, for example with a tooth-

brush.

Note: Do not submerge the hose in water.

5. Screw the ﬂexible hose back onto the tap by hand.

Do not use pliers (risk of squashing the joint).

6. Turn on the tap and check that the connections

are water-tight.

7. Plug the washing machine back in.

Water inlet hose

(picture 22, 23 or 24, depending on model)

Check the inlet hose regularly for brittleness and

cracks and replace it if necessary using a new hose of

the same type.

The inlet hose as shown on picture 22 has a safety

valve to prevent the appliance against uncontrolled

water inlet; if the safety valve inspection window (A) is

red, the safety valve has been activated and the hose

must be exchanged. Contact out After-Sales Service

or your specialist dealer to obtain a new inlet hose.

For unscrewing the inlet hose as shown on picture 22,

you must push down the release lever (B) (if available)

while unscrewing it.

If your inlet hose has a transparent hose coating

(picture 23), periodically check the colour of the

transparent coating. If the transparent hose shows a

local dark colour change, this is an indication that the

hose may have a leak and should be replaced.

Contact our After-Sales Service team or specialist

dealer to obtain a replacement hose.

Appliance exterior and control panel

• Clean with a soft damp cloth.

• If necessary, use some soapy water or a mild

neutral detergent (do not use detergents containing

solvents, abrasive detergents, window or general-

purpose cleaners - they may harm the surfaces).

Appliance interior

• After each washing, leave the lid open for some-

time to allow the inside of the appliance to dry.

• If you never or seldom wash your laundry at

95°C, we recommend to occasionally run a 95°C

programme without laundry, adding a small amount

of detergent, to keep the interior of the appliance

clean.

Lid seal

• Check the condition of the lid seal periodically and

clean it from time to time with a damp cloth.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whirlpool ZEN TDLR724 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Whirlpool ZEN TDLR724

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info