Bedienungsanleitung White Knight ECO43A (Seite 6 von 8) (Englisch)

484233

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

SECTION 5: DRYING YOUR LAUNDRY (CONT)

* Drying

When starting the dryer for the first time, or starting after temporary disconnection from the gas supply,

air in the pipes will prevent ignition. To clear this air, the dryer must be started by turning the timer to a

setting of at least 30 minutes. Allow the dryer to operate for 1/2 minute before stopping the dryer. Repeat

this process until continuous burning of the gas is indicated by the neon light on the control panel.

- Open a nearby window to allow for the circulation of fresh air, even if using a vent hose.

- Open the dryer door.

- If drying sheets, load before other items, starting with one corner.

- Load clothes loosely into the drum.

- Close the dryer door.

- Dry your hands.

- Check that the timer is in the '0' position.

- Plug in the machine.

- Select correct heat setting (see programme chart around timer for recommendations).

- Select the timer to the required time setting, press start button (see programme chart on control panel for

recommendations).

- The drum will begin rotating. Reversing drum models will stop after approximately 5 minutes of normal

operation to rotate the drum in the reverse (anti-clockwise) direction for 10 seconds. The dryer does not

heat while rotating in the reverse direction.

- Should the clothes become dry before the cycle has finished, or if an excessive programme time has been

selected, the drum will continue to rotate while the thermostat will automatically regulate the heater to

reduce the risk of over-drying.

- There is an automatic 12 minute cool down period at the end of every cycle, during which the heater is

switched off. This helps to minimize creasing, and must always be used fully to avoid the risk of fire.

NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM - RISK OF

FIRE.

- When drying large items such as sheets, we suggest you periodically stop the dryer to redistribute the

load.

- To stop the machines during the middle of the programme simply open the door; the drum will stop

rotating automatically. To start the machine - close the door and press the start button.

- To lengthen or shorten a timed programme, open the door, reset the timer knob, close the door and press

the start button.

To lengthen or shorten a timed programme, reset the timer knob.

* After removing the dried clothes

ALWAYS CLEAN THE FILTER. Failure to clean the filter will extend drying times and could cause

the safety cut-out to operate.

- Pull the filter upwards and away from the appliance

- Remove any threads or fluff by hand or with a soft brush.

- Slide the filter back.

- Wash the filter occasionally in detergent solution and with a soft brush to remove

small particles.

- If your filter becomes damaged, replace it to ensure no damage is caused to the

dryer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

White Knight ECO43A Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info