Bedienungsanleitung White Knight ECO86A (Seite 9 von 12) (Englisch)

484234

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Once the Start button has been pressed, the program is locked and all buttons are disabled. To stop the

machine and unlock the buttons - open the door

There is an automatic 12 minute cool down period at the end of each cycle, during which the heater is

switched off and the green cool indicator is on. This helps to minimize creasing, and must always be used

fully to avoid the risk of fire.

DELAY START

To use the Delay Start feature press the Delay Start button before pressing the Start button. The Delay

Start display will show 1 hour of delay time. Repeated pressing, or holding down, of the Delay Start

button will increase the amount of delay time to a maximum of 9 hours. To cancel Delay Start, press the

Reset button. To start the delay period press Start. The delay time will start to count down in the display

window. To cancel Delay Start once the countdown has started, de-power the machine by opening the

dryer door.

NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM DUE TO THE

RISK OF FIRE.

- When drying large items such as sheets, we suggest you periodically stop the dryer to redistribute the

load.

- To stop the machines during the middle of the programme simply open the door; the drum will stop

rotating automatically. To restart the machine, close the door, press the Activate button and then press the

Start button.

* After removing the dried clothes

ALWAYS CLEAN THE FILTER. Failure to clean the filter will extend drying times and could cause

the safety cut-out to operate.

SECTION 6: ADDITIONAL INFORMATION

* Any Problems?

If the clothes are not dry after normal drying time:

- Check that you have selected an appropriate programme and heat setting

- Check that the lint filter has been cleaned. A blocked filter will restrict the airflow.

- Check that the venting system is clear, and the front air inlet is not blocked.

- Ensure the dryer is not overloaded. Restart the appliance with ‘Extra Dry’ selected and the heat switch

on the high setting, press Activate and then Start buttons and observe the neon remains lit for more than

one minute. If the neon goes out within the minute wait a further three minutes before stopping and

restarting the appliance by opening and closing the door and pressing the Activate button and then the

Start button. Observe the neon remains lit for more than one minute and the appliance continues to heat

throughout the cycle (the window remains warm) and the clothes are dry at the end of the cycle.

- Pull the filter upwards and away from the appliance

- Remove any threads or fluff by hand or with a soft brush.

- Slide the filter back.

- Wash the filter occasionally in detergent solution and with a soft brush to remove

small particles.

- If your filter becomes damaged, replace it to ensure no damage is caused to the

dryer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

White Knight ECO86A Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info