Bedienungsanleitung Whynter ARC-148MHP (Seite 13 von 19) (Englisch)

727502

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

OPERATION INSTRUCTIONS

•In heating mode, cold air is exhausted from the outdoor exhaust port and the exhaust hose must be connected to

exhaust out the cold air.

•The temperature setting range is from 61F to 77F. To set the temperature, press the + or – buttons. Once the set

temperature is achieved, the compressor and the fan will stop.

•To set the fan speed, press the Fan Speed button. In heating mode, the difference in noise level between the 3

fan speeds is not very noticeable when the compressor is on. Try setting the unit to Fan only mode, you should

be able to hear the difference between high and low fan speed settings.

NOTE: This unit uses heat pump from heating and the heating mode does not work when temperature is below

45F.

FAN ONLY MODE

In this mode, only the fan of the air conditioner runs and circulates the air in the room. To activate this function mode,

press the MODE button until the FAN indicator light comes on. In this function mode, the temperature cannot be

set. Subsequently, set the desired fan speed by pressing the FAN button. When using FAN only mode, venting the

exhaust hose to the outside is optional.

TIMER (DELAYED SWITCH ON / OFF) FUNCTION

This function mode enables a delayed switch ON or delayed switch OFF of the air conditioner. The time (hours) de-

lay can be set, enabled and disabled.

SETTING SWITCH OFF TIMER

With the air conditioner operating in any function mode, press the TIMER button. The TIMER OFF light will come on.

Then set the desired time delay OFF hours by pressing the UP and DOWN buttons. The time increments are at 0.5

hour to up to 10 hours, followed by 1 hour increment up to 24 hours. When the delay time set has elapsed, the air

conditioner switches off. To cancel the delayed switch off function, turn off the air conditioner or adjust the time set-

ting to 0.0.

SETTING DELAYED SWITCH ON TIMER

With the air conditioner is off, press the TIMER button. The TIMER ON light will come on. Then set the desired time

delay ON hours by pressing the UP and DOW N buttons. The time increments are at 0.5 hour to up to 10 hours, fol-

lowed by 1 hour increment up to 24 hours. When the delay time set has elapsed, the air conditioner switches on. To

cancel the delayed switch on function, turn on the air conditioner or adjust the time setting to 0.0.

SLEEP MODE

In this mode, the air conditioner gradually increases the set temperature in cooling mode, decreases the noise level

and conserves energy. In Economy and cooling mode, the set temperature is increased by 1°C/ 2°F in the first 30

minutes. The temperature will then increase by another 1°C/ 2°F after an additional 30 minutes. This new tempera-

ture will remain the same for 7 hours. To activate this function mode, press the SLEEP button until the SLEEP

indicator light comes on.

AUTO RESTART

In the event of a power outage, the air conditioner restarts at the previously set function mode and settings when

power is restored.

CONTROLLING THE AIR FLOW DIRECTION

The louvers can be controlled to Auto-Swing or in a fixed direction. To control the air flow direction by Auto-Swing,

press the SWING button. To set the louvers in a fixed angle or direction, press SWING button while on Auto-Swing

mode when desired angle is chosen.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whynter ARC-148MHP Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info