Bedienungsanleitung Whynter CDW-6831WES (Seite 23 von 26) (Englisch)

727527

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Caring for the Dishwasher

• The control panel can be cleaned by using a lightly dampened cloth and dry thoroughly.

• The exterior can be cleaned using an appliance polish wax.

• Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.

Cleaning The Door

To clean the edge around the door, use only a soft cloth dampened

with warm water. To avoid penetration of water into the door lock and

electrical components, do not use a spray cleaner of any kind.

WARNING!

• Never use a spray cleaner to clean the door panel as it may damage

the door lock and electrical components.

• Abrasive agents or some types of paper towels should not be used

because of the risk of scratching or leaving spots on the stainless

steel surface.

Protect Against Freezing

Please take frost protection measures on dishwasher in winter. After all washing cycles, please

operate as follows:

.1 Unplug the dishwasher from the power source.

.2 Turn off the water supply and disconnect the water inlet pipe from the water valve.

.3 Drain water from the inlet pipe and water valve. (Use a pan to catch the water)

.4 Reconnect the water inlet pipe to the water valve.

.5 Remove the filter and use a sponge to absorb excess water.

Cleaning the Spray Arms

The spray arms can be easily removed for periodic clean-

ing of the nozzles, to prevent possible clogging. Wash them

under running water and carefully replace them in their

seats, checking that their rotary movement is in no way im-

peded. Grasp the middle of the spray arm, pull it upwards

to remove it. Wash the arms under a jet of running water

and return them carefully to their seat.

After reassembly, check that the spray arms turn freely.

Otherwise, check if the sprays arms are installed correctly.

How to Keep Your Dishwasher in Shape

 After Every Wash

After every wash, turn off the water supply to the appliance and leave the door slightly open so that moisture

and odors are not trapped inside.

 Remove the Plug

Before cleaning or performing maintenance, always remove the plug from the socket.

 No Solvents or Abrasive Cleaning

To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products.

Only use a cloth with warm soapy water. To remove spots or stains from the surface of the interior, use a

cloth dampened with water with a little vinegar, or a cleaning product made specifically for dishwashers.

 When it is not needed for a long time

It is recommend that you run a wash cycle with the dishwasher empty and then remove the plug from the

socket, turn off the water supply and leave the door of the appliance slightly open. This will help the door

seal to last longer and prevent odors from forming within the appliance.

 Moving the Appliance

If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be posi-

tioned on its back.

 Door Seal

One of the factors that cause odors to form in the dishwasher is food that remains trapped in the seal. Peri-

odic cleaning with a damp sponge will prevent this from occurring.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Whynter CDW-6831WES Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info