11
no. 30) and lifting it o.
6. Install the cover plate on top of the stove with the three screws.
7. Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with the
three screws.
8. Place the rear plate on the stove again.
9. Replace the top plate on stove.
A top cover can be bought as an accessory to cover the hole in the top plate of the stove
if the stove is connected to a rear smoke outlet.
Changing the Smoke Outlet from Top Outlet to Rear Outlet
(WIKING Luma 5 - Luma 6) (Figure F)
Proceed as follows to change the smoke outlet from top outlet to rear outlet:
1. Lift the top plate o the stove.
2. Lift the rear plate o the stove.
3. Lift the front (1) of the heat storage compartment up and forward, unhooking it from the
four guide pins (2).
4. Loosen and remove the three screws in the ue ring (3) in the bottom of the heat storage
compartment. Remove the smoke ring.
5. There is a cut-out for the ue duct in the back plate. Break o the plate (4) within this
cut-out to make a hole that the ue duct can t into. It is recommended that you use a
wire- cutter.
6. Remove the cover plate at the rear of the stove by loosening and removing the three
screws (Torx Bit no. 30) and lifting it o.
7. Mount the cover plate over the smoke outlet in the bottom of the heat storage compart
ment, using the three screws.
8. Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with
the three screws.
9. Hook the front (1) on to the four guide pins (2).
10. Place the rear plate on the stove again.
11. Place the top plate on the stove again.
A top cover can be bought as an accessory to cover the hole in the top plate of the stove if the
stove is connected to a rear smoke outlet.
The adjustable feet (Figure B1 and B2)
WIKING Luma is delivered with four adjustable feet that can be tted, as needed. Open the
door under the wood section. Loosen the screws (1) in each side of the vertical cover plate
in the back of the chamber. Lift up the cover plate (2), tilt the lower part forward and pull the
cover plate out. Mount and adjust the adjustable feet screws (3) in accordance with the sepa-
rate instructions, 2 in each side, to the desired height. Hook the cover plate back in place and
tighten the two screws.
The adjustable feet on WIKING Luma 1/Luma 2 must be adjusted from the rear of the stove.
Lift o the top plate. Lift o the rear plate. Remove the screw (4) and lift o the side plate. Lift
o the heat shield (5). Mount and adjust the adjustable feet screws (6) in accordance with the
separate instructions, 2 in each side, to the desired height. Mount the heat shield, side plate,
rear plate and top plate again.
WIKING Luma 1 and WIKING Luma 2 on pedestals have no adjustable feet.
