- Keep the batteries out of reach of children
- Non-rechargeable batteries should not be recharged
- Unequally charged batteries or different battery types should
not be used together
- Use recommended batteries or similar
- After using the copter, remove the batteries if you will not use
it again for a long period of time
- The terminals must not be short-circuited
- This model is equipped with a rechargeable Li-po Battery. Li-
po batteries require special attention, follow the manual
- The batteries must be charged with the charger supplied by
WLtoys
- When charging the battery, always ensure that you do so on a
non-combustible surface
- Do not leave charging without supervision
- Always charge the battery to 100%
- Ensure that the battery wires are not in contact to avoid a
short-circuit
- The ignition wires of the battery must not be modified or
damaged
- Never damage the battery mechanically (this could cause an
explosion)
- The battery should not be placed near children (unless you
have an adult supervision)
- The technical design of the battery must not be changed
- Touching of damaged batteries can cause injury. If there is
contact with skin or eyes, seek medical attention immediately!
- Do not charge directly after the flight or when the battery is
warm
Option A : Via the remote wire (V252/V939/V911)
1. Wire
2. Support
3. LED
4. Batteries
Unplug the connector from the remote and put it into the
charging station. Switch on the remote and put one or both
batterie(s) in the charging station. The light of the charging
station will be red. After one hour the light will turn off meaning
that the battery is fully charged.
Option B : Via USB
Connect the USB plug of the charging station with a computer
or other electronic device. As soon as the charging station is
connected you will see a red light. After one hour the light will
turn off meaning that the battery is fully charged.
Please disconnect the charging station as soon as the red light
of the charging station is off.
