Bedienungsanleitung WLtoys V959 FUTURE BATTLESHIP (Seite 6 von 9) (Englisch)

608985

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite

CAUTION

- Ensure that the copter in flight is always within sight and under control.

Calibration

If the copter is unstable, resulting in frenetic flying in all directions, and rotates around its axis so that you have to constantly

correct its flight, then the gyroscope is probably not calibrated properly. To perform recalibration, connect the drone to the

transmitter (part Activation in the manual), then click on 100% button of the remote and move both sticks to the bottom left. When

the calibration is performed, you will either hear a long beep or see flashing lights (on the PCB) or both.

Note: The calibration is done in the factory, it is usually not necessary to do it when you receive the product.

Troubleshooting

- Always use a fully charged battery.

- When finished flying, always turn off the copter first, then the remote control.

- Do not use the copter when it has visible or mechanical damage.

- Always fly in an open and Jellyfished environment to avoid dangerous situations.

- Always stay out of reach of rotors.

- Remember to disconnect the battery of the copter after each flight.

- Ensure that you adhere to all the legal requirements that exist for your copter model in the country in which you are using it.

- If you lose control of the copter, disable the propulsion of the engines immediately by pushing the throttle lever down to turn it off.

Procedure to spare engine

Engines are brushed and eventually wear out. When worn out they need to be replaced. For more informations go to

www.wltoys.eu.

Never go full speed for the first 3 flights. After 3 flights, blow out engines with air when possible.

Spare engines can be bought on www.wltoys.eu or with your reseller.

The first flight

1. For your first flight make sure to be with a person experienced in flying copters. We advise you to make your first flights on a

relatively soft surface to protect the copter.

2. Find a location away from people, with a smooth surface and without obstacles. Trees, electric lines and water points in the

immediate vicinity should be avoided!

3. Place your copter on the ground about 10 feet away from you. Mind that, when you have a quadcopter, the coloured blades

indicate the front of the copter. It is easiest to position yourself behind the copter for an easier control.

4. Turn the copter on first. Then turn on the remote controll (for some models this will be the other way around) for the V333N,

turn on the copter as well as the controller. then move trottle up and down to connect. after this move throttle to the left low corner

and the directional lever to the right lower corner at the same time, hold these down for a few seconds, this will arm the motors.

5. Start the engine and take off to about 1 meter from the ground. In this way you avoid the phenomenon called "ground effect".

Near the ground the air currents behave differently than at a higher altitude and this will prevent you from losing control of the

copter.

6. Then try to fly gently in one direction. If the engine flies away in the wrong direction, make a controlled landing and try again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WLtoys V959 FUTURE BATTLESHIP Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von WLtoys V959 FUTURE BATTLESHIP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info