Bedienungsanleitung Wmf Coup - 0416290011 (Seite 12 von 64) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Norwegisch, Finnisch)

551536

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

Start-up

▪ Clean the glass jug (3), lid (2) and closing cap (1) before starting up the appli-

ance for the ﬁrst time. Ensure that you do not injure yourself on the sharp

blade.

▪ Place the appliance on an even surface and position the glass jug (3) on the

drive unit (8).

▪ Add the ingredients to the jug (3) and close it with the lid (2) and the closing

cap (1).

Additional ingredients may be added by removing the closing cap (1), even

while the motor is running.

Note: Ensure that you do not exceed the maximum ﬁlling quantity of 0.8 l. If

you are using hot, very liquid or slightly foaming food (e.g. milk), we advise

using 0.5 l as the maximum ﬁlling quantity.

Note: Never operate the appliance empty.

▪ Start the appliance by turning the selector switch (8) to the right. Start at a

low speed and increase it if necessary.

To use the Pulse function, hold the selector switch (8) to the left on the Pulse

level. The motor will operate at maximum speed for as long as you keep the

selector switch (8) on the Pulse level.

▪ As soon as the desired result has been achieved, switch the selector switch (8)

to the Off position

. Only then should you remove the jug (3).

Attention! Risk of injury! Always wait for the blade (2) to come to a

standstill before removing the lid. Do not reach into the appliance before

the mains plug has been unplugged. Completely empty the glass jug (3)

following use. Do not leave any liquid in the jug (3).

Examples Speed

Maximum

time

Maximum ﬁlling

quantity

Instant drinks, cocktails Low

(min.)

40 – 60 s 500 ml

Soft fruits (e.g. bananas,

apricots)

Low

(min.)

40 – 60 s 250 g

Milkshakes / smoothies with

soft fruits

Low

(min.)

1 – 2 mins. 250 g of fruit + 150

ml of milk / juice

Soups, sauces Medium 1.5 – 2 mins. 500 ml

Milkshakes / smoothies with

harder fruits

Medium 1.5 – 2 mins. 250 g of fruit + 150

ml of

milk / juice

Vegetables Medium 1.5 – 2 mins. 250 g

Frappés Medium 1.5 – 2 mins. 250 ml of coffee +

4 ice cubes

Milkshakes / smoothies

with frozen fruits, green

smoothies

High

(max.)

40 – 60 s 250 g of fruit + 150

ml of

milk / juice

Crushing ice cubes

Add a maximum of 6 ice cubes and close the glass jug (3) with the lid (2) and

closing cap (1). Move the selector switch (8) to the Pulse level for a few seconds

and then back to the Off position

. As soon as the ice cubes have fallen back to

the bottom of the glass jug (8), you can switch to the Pulse level again for a few

seconds. Repeat the process until the crushed ice has the desired consistency.

Note: For a more homogeneous result, add some water to the ice cubes.

Glass jug

Lid with closing cap

The closing cap (1) in the lid (2) can be removed and used as a measure (10 / 20 /

30 ml) by turning it anti-clockwise.

The lid (2) reliably and tightly seals the glass jug. The lid (2) has a tab which you

can use to make it easier to remove the lid.

You can add more ingredients through the opening, even during operation.

Disassembling the glass jug

The glass jug (3) can be disassembled, especially for cleaning.

Remove the lid (2) and the closing cap (1). Place the glass jug (3) on the table

with the opening face-down and turn the locking screw (6) on the blade unit (5)

clockwise (see the figure). You can now remove the blade unit (5) and the sealing

ring (4).

To assemble the glass jug, the sealing ring (4) is ﬁrst of all attached to the blade

unit (5). When doing so, ensure that the sealing ring (4) is correctly positioned on

the blade unit (5). Then insert the blade unit (5) into the glass jug. (3) and ﬁrmly

turn the locking screw (6) anti-clockwise.

Note: To ensure the tightness of the glass jug (3), the blade unit (5) must be

screwed on tightly. The blade unit (5) is easier to tighten if you apply a few drops

of cooking oil on the sealing side of the glass jug (see the ﬁgure).

Cleaning and maintenance

Remove the mains plug after use. Under no circumstances should you immerse

the drive unit (8) in water. Simply wipe the outside with a damp cloth. Do not

use any abrasive cleaning agents. Ensure that you do not injure yourself on the

sharp blade when cleaning the glass jug (3). Immediately after blending, ﬁll

the jug with warm rinsing water and allow the motor to run for a few seconds.

Then remove the glass jug (3) and clean with a washing-up brush. For thorough

cleaning, you can disassemble the glass jug as described in the section entitled

“Disassembling the glass jug”.

For quick and easy cleaning, you can place all loose parts in the dishwasher.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wmf Coup - 0416290011 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info