Bedienungsanleitung Wodtke CW 21 Airplus S4 (Seite 15 von 83) (Englisch)

813070

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

Bedienungsanleitung Steuerung S4_2006_09_25-neu.doc Page 15 / 83

5.3.1 Special notes on the initial operation of Waterplus appliances

Waterplus appliances must never be put into operation without water or without being

connected to the heating system! Even a short test run without water can cause

considerable damage to the appliance, and in any case voids all warranty claims. Never

bridge or remove any of the safety devices.

Prior to initial operation the boiler of the Water appliance must be connected to the heating

system (storage heater, radiator, wall heating or the like) via a wodtke stove connecting station*.

The entire system must be properly deaerated. The heating system must be capable of

delivering heat (radiators turned on, storage cold).

*If you are not using a wodtke stove connecting station, the return temperature must instead be

raised to >50 °C (ideally 55 °C) and a pump control facility must be installed.

5.3.2 Filling the fuel hopper

Open the hopper lid wearing heat protection gloves. Open the pellet bag at the seam and place

it in the fuel hopper with the opening face down touching the protective grating and

slowly draw the bag out. This prevents the pellets from falling into the hopper from a height

and unnecessarily throwing up dust. With appliances of the Smart series (protective grating

located higher up) refill pellets slowly from a low height. After refilling, close the hopper lid and

keep it closed during operation.

Tip: Pour the pellets slowly from a low height to cause as little dust as possible (see above).

You can also use a bucket or the like for filling pellets into the fuel hopper.

When starting up for the first time the feed screw will still be empty. The first pellets will fall into

the burner pot when the appliance has been running for about 10 minutes and the ignition

system has switched off again. The same applies when the fuel hopper has been refilled too

late and the last pellets have passed the feed screw.

In either case, do the following to ensure reliable ignition:

• Switch appliance on using the I/O key and wait until the preheating programme has finished

or pellets start dropping into the burner pot.

• At this moment switch the appliance off and then immediately on again using the I/O key.

The preheating programme will then start anew and the appliance will light as soon as

pellets start dropping into the burner pot. Repeat this procedure as necessary.

Tip:

If the fuel hopper and the feed screw have run completely empty you can shorten the time

needed until pellets start dropping into the burner pot and the appliance lights again by dropping

a handful of pellets into the burner pot or filling it up to the first row of holes. Note: Do not fill the

burner pot completely; this would cause malfunctioning.

5.3.3 External feed systems

wodtke has special accessories available for connecting the appliance to pellet feed systems or

storage spaces provided as part of the domestic equipment. Our appliances are approved for

external feeding. For this purpose we recommend automatic gravity feed systems with a pellet

storage space located directly above the place where the fuel hopper is normally mounted on

our appliances. Then the pellets can simply slide down from the storage space into the hopper

through gravity, with no need for maintenance or auxiliary energy. Alternatively one can also

use electrical or pneumatic feed systems. In this regard please observe our additional technical

instructions and in particular your local building regulations.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wodtke CW 21 Airplus S4 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wodtke CW 21 Airplus S4

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info