Bedienungsanleitung Wodtke Family.nrg (Seite 7 von 68) (Englisch)

813057

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Manual_S5_Airplus_2015_04_20 Page 7 / 68

3.4.3 Room Air Independent

Operation

The required combustion air is supplied to the fur-

nace directly via a sealed connection line from the

outside, and not extracted from the installation

room of the heating system.

The furnace is suitable for room air independent

operation (DIBt approval). The following must be

observed:

 The combustion air line and the flue

pipes must be sealed.

 In addition, a negative pressure no

greater than 8 Pa relative to the outside

may occur in the installation room, the

residence or a comparable usage unit

due to room air extracting systems.

The general building approval by the DIBt is num-

ber Z-43.12-240.

3.4.4 Combination with Controlled

Venting and Ventilation Systems

If the furnace is installed in the effective range of

a controlled venting and ventilation system, §4 of

the fire-heating installations ordinance (FeuVo)

applies in Germany. The following options there-

fore exist, among others, for operation of the fur-

nace in combination with room air technology sys-

tems:

 A room air independent connection or

operating method must be ensured (see

above).

 The exhaust gas routing must be moni-

tored by special safety equipment (this

can be done with the wodtke differential

pressure controller DS01, for example;

see price list).

 Use of a ventilation system which en-

sures that negative pressures no greater

than 4 Pa relative to the outside occur in

the installation room and that the re-

quired combustion air (approx. 25 m3/h)

is additionally supplied for the heating

system.

3.5 Chimney Connection

A chimney calculation must be performed before

installation (EN 13384). The chimney provides for

the safe removal of flue gases from the furnace,

particularly in case of power failure, and is thus re-

sponsible for an important safety function and

must be properly sized. In the case of a chimney

draught that is too high, we recommend installing

a draught limiter. The conveying pressure (= chim-

ney draught) must be between 3 Pa at minimum

and 20 Pa at maximum.

The heating system must be connected to a

chimney which is suitable for solid fuels. The

connection piece must be made of metal and

fulfil the corresponding requirements accord-

ing to the DIN / EN standard. The authorised

district chimney sweep will be happy to advise

you in advance.

Additional safety equipment is required when

connecting Pellet-Primärofens to chimneys

which have multiple connections.

Please always observe the respective local regu-

lations and rules, in consultation with your author-

ised district chimney sweep. We can accept no

liability for changes which occur after printing of

these instructions. We reserve the right to make

changes without notice.

3.6 Combustion Air Connection

If the furnace is intended for room air independent

operation, the combustion air line must be gas-

tight. wodtke combustion air lines with sealing

rings (see wodtke price list) can be used for this.

To reduce cooling losses and to thereby save en-

ergy, wodtke has the special motorised flue gas

damper, which can be used an intake and flue

gas damper.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wodtke Family.nrg Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wodtke Family.nrg

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info