Bedienungsanleitung Wodtke Frank Airplus S4 (Seite 35 von 83) (Englisch)

813077

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

Bedienungsanleitung Steuerung S4_2006_09_25-neu.doc Page 35 / 83

Note:

As a consequence of wodtke air flow sensor technology the appearance of the flames may

change with changing draught conditions in the chimney and air temperature because the

speed of the fan varies in response to these parameters. This is perfectly normal and in no way

a shortcoming. It is rather this very feature that makes for optimal combustion.

The air flow sensor system also responds to the firedoor being opened, interrupting the pellet

supply. This makes it impossible to operate the appliance with the door open and classifies it as

design type 1 (self-closing door), permitting several stoves to be operated with one chimney if

this is suitably designed.

The air flow sensor also permits the temperature of the air flow sensor (TL) in the suction pipe

to be measured. Any temperature increase beyond the desired range, and any temperature

increase that is too fast (gradient), will trigger an error shutdown.

7.6 Temperature sensor at pellet chute (TP)

Located directly in the pellet chute is a temperature sensor which monitors the temperature

towards the fuel hopper. Any temperature increase beyond the desired range entered into the

software will trigger an error shutdown.

7.7 Temperature sensor at flue gas fan (TR)

Located directly at the flue gas fan is a temperature sensor which monitors the temperature.

Any temperature increase beyond the desired range entered into the software will cause the

appliance to go into modulation mode “H.M” (minimal output)  see also Chapter 0. Pellets with

a high calorific value or bulk density can cause the actual thermal output of the appliance to

exceed its nominal output. This is detected by TR and duly compensated. The appliance is then

modulated to run at minimum load until it meets the prescribed values again.

7.8 Temperature cutoff (STB) + main fuse

The temperature cutoff is a mandatory safety device which switches off the appliance in the

event of excessive overheating and then has to be released manually. The location of the

release differs between models. The main fuse of the appliance is always located close to the

STB.

Position of STB + main fuse (5A, quick

acting)

Position of STB + main fuse (5A, quick

acting)

“CW 21“, “Smart“, “Topline“, “Frank”

Series “PE“

Underneath black screw cap on rear panel of stove

On the right behind the inlet grille

The STB can be released with a pointed object as soon as the appliance has cooled down

sufficiently. If the STB doesn’t stay pressed in, the temperature is still too high and the

appliance should be allowed to cool further before making another attempt.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Wodtke Frank Airplus S4 Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Wodtke Frank Airplus S4

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info