Bedienungsanleitung WOLF-Garten 2.40 BS (Seite 11 von 34) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

638020

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

Maintenance

Disconnect spark plug cap and starter key before proceeding (fig. W1/W2)

Clean mower thoroughly after each mowing with cloth or brush. Do not spray with water. Keep mower in a dry room.

Change oil only

While engine is warm and fuel tank empty.

Change oil after the first 5 working hours. Thereafter chane engine oil every 25 working hours and at the end of the mowing season.

Change engine oil more frequently if working under extreme and dusty conditions. To drain the engine oil, remove oil filler cap, tilt

machine slowly to side and allow oil to drain from the crankcase through the filler.

Cleaning of Spark Plug

Check and clean regularly, reset plug gap as required (0,76 mm).

Cleaning of air filter

Refer to the engine manufacturer‘s handbook supplied.

Cleaning operations and blade change (fig. W1)

Tilt the mower towards rear for cleaning operations and blade change: Detach spark plug cable. Fold upper part of handle forwards

(avoid damage to Bowden cables).

Sharpening and changing blade (fig. W3)

Blade should always be sharpened by an approved Service Centre. Change blade according to drawing.

Gloves should be worn at all times when working on the blade. Remove ignition key and spark plug lead when working on

the blade. Information for Service Centre, blade retaining screw to be tightened to: screw = 38-42 Nm.

Winter storage

• Drain fuel tank.

• Drain carburettor

- therefore start engine, keep it runninug until it automaticalli switches off.

• Clean the whole machine thoroughly

• Change oil, 4-stroke engine.

• Prepare engine for winter storage as follows:

- Remove spark plug

- Poor one spoon full of engine oil into spark plug hole

- Pull starter rope slowly to distribute oil evenly inside cylinder

- Replace spark plug but do not connect spark plug lead

- Pull starter rope until resistance is felt (valves are now closed)

• Store mower in a cool and dry place.

We recommend: Have your mower thoroughly checked once a year by approved Service Agent.

Faults and how to remedy

Remedy (X) by:

Problem Possible cause

WOLF

service

workshop

Yourself

Motor does not start or

has no power:

• Insufcient fuel in the tank

• Spark plug lead not connected

• Spark plug out of order

• Air lter dirty or oily

• Throttle lever not at „Run“

• Blade fastening screw loose

• Clutch linings worn

---

Uneven cutting:

• Cutting height misadjusted

• Blunt blades

• Air / duct catcher bag blocked

---

When in doubt, always consult a WOLF service workshop. Important: switch off the mower and disconnect the spark

plug lead before inspecting, cleaning or working on the blades.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten 2.40 BS Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info