Bedienungsanleitung WOLF-Garten Campus 440 BA (Seite 14 von 33) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

638129

Zoom out

Zoom in

Vorherige Seite

1/33

Nächste Seite

Operation

Operating times

Please check noise abatement regulations prevailing in your

country.

Oil Fill

Before starting the lawnmower, check the engine oil level.

Before starting the mower, add 0.5 to 0.6 litre of SAE 30 brand

oil. Insert the dipstick into the oil filling opening and push it

down to the thread. Pull out the dipstick. The oil must reach the

"Max" mark on the dipstick (no oil above "Max" mark). Screw

in the dipstick.

Filling with Petrol

Do not smoke - no naked flames!

off engine.

Avoid spilling petrol when engine is warm.

Use „low-octane petrol“ (do not use Super Plus).

Avoid petrol spillage.

Do not inhale vapour.

Hanging the grass bag

Attach and remove the bag only when the engine is

switched off and the cutting gear is standing still!

1. Lift the protective flap.

2. Attach the grass bag to the holders attached to the

chassis (see arrow).

3. Lower the protective flap.

Use of height adjustment

Only when mower is stationary and rotating blade

has come to complete standstill.

Campus 400 B

• Remove the front and rear wheels and remount them at the

same height

Campus 440 BA

• Front wheels: Remove both wheels and remount them at

the same heigh

• Rear wheels: Pull the lever out and engage it at the desired

cutting height

The rear and front end of the chassis must be at

the same distance to the lawn.

Start

• On a at surface, if possible not in high grass.

1. Pull out the choke

2. Raise and hold the safety bracket

(1)

3. Pull starter grip

and return it slowly by hand.

4. Push the choke back

as soon as the engine

has warmed up

Wheel drive

1. Wheel drive on: Raise drive bracket

(2).

2. Wheel drive off: Relapse drive bracket

(2)

Stop Motor

Release safety bracket

(1).

Tips for mowing

• To prevent strips of grass from being left unmowed, the

cutting paths must always overlap a few centimeters.

• Always turn the mower on a surface that has already been

mowed.

Emptying the grass bag

Only when mower is stationary and rotating blade

has come to complete standstill.

The grassbox is full and should be emptied as soon as grass

clippings remain uncollected on the ground behind your mower.

Maintenance

Disconnect spark plug cap and starter key before

proceeding

Clean mower thoroughly after each mowing with cloth or

brush.

Do not spray with water. Keep mower in a dry room.

Cleaning mower and changing blade

1. Remove the spark plug.

2. For cleaning and blade change, position the mower as

shown in figures

Change of Cutter blades

Disconnect spark plug cap and starter key before

proceeding

Blade should always be sharpened by an approved Service

Centre. Change blade according to drawing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten Campus 440 BA Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info