Bedienungsanleitung WOLF-Garten Campus 460 BA (Seite 13 von 32) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

638609

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Operation

Operating times

Please check noise abatement regulations prevailing in your

country.

Oil Fill

Check oil level with mower standing on level ground.

Fill crankcase with quality oil SAE 30 up to the mark „Full“ on

dipstick. (Do not overfill.) Capacity approx. 0,6 litre. Screw in

dipstick according to illus.

Filling with Petrol

Do not smoke - no naked flames!

off engine.

Avoid spilling petrol when engine is warm.

Use „low-octane petrol“ (do not use Super Plus).

Avoid petrol spillage.

Do not inhale vapour.

Hanging the grass bag

Only when mower is stationary and rotating blade

has come to complete standstill.

1. Lift the protective ﬂ ap.

2. Hang the grass bag in the chassis with the hooks in the

recesses (see arrow).

3. Replace the protective ﬂ ap.

Use of height adjustment

Only when mower is stationary and rotating blade

has come to complete standstill.

• Place hand into handle bar and depress button (1). Lift or

lower chassis until it engages into required position (2).

• The wheels must all be at the same cutting height

setting!

• If possible, mow when grass is dry in order to protect turf.

Do not set cutting position too low when mowing very tall

or wet grass.

Start

• On a ﬂ at surface, if possible not in high grass.

1. Firmly press the primer on the motor (three times)

(1).

2. Raise and hold the safety bracket

(1).

3. Pull starter grip

and return it slowly by hand.

4. Push the choke back as soon as the engine has warmed

Wheel drive (Campus 460 BA)

1. Wheel drive on: Raise drive bracket

(2).

2. Wheel drive off: Relapse drive bracket

(2)

Stop Motor

Release safety bracket

(1).

Tips for mowing

• To prevent strips of grass from being left unmowed, the

cutting paths must always overlap a few centimeters.

• Always turn the mower on a surface that has already been

mowed.

Emptying the grass bag

Only when mower is stationary and rotating blade

has come to complete standstill.

The grassbox is full and should be emptied as soon as grass

clippings remain uncollected on the ground behind your mower.

Maintenance

Disconnect spark plug cap and starter key before

proceeding

Clean mower thoroughly after each mowing with cloth or

brush.

Do not spray with water. Keep mower in a dry room.

Cleaning operations and blade change

1. Pull off the sparkplug connector!

2. Raise the cutting height to its highest position

3. For cleaning work and blade replacement tilt the mower back

as shown in the illustration.

Change of Cutter blades

Disconnect spark plug cap and starter key before

proceeding

Blade should always be sharpened by an approved Service

Centre. Change blade according to drawing.

Information for Service Centre, blade retaining screw to be

tightened to: screw = 51-68 Nm.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten Campus 460 BA Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info