Bedienungsanleitung WOLF-Garten Esprit 40 BAK (Seite 28 von 34) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

638106

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

Starting Esprit 40 B/40 BK/40 T/46 B (fig. B5/B6/B8)

Place mower on level ground, not on tall grass. Throttle lever B6 (1) to „Betrieb“ (=run). Cold starting: Firmly press the primer on the engine

B5 (2), (Esprit 40 B/BA/BK/BAK, 46 B/46 BA three times), (Esprit 40 T/TA four times). Lift and hold operator presence bail arm B6 (3). Pull

starter rope B8 (4) rapidly and return starter grip slowly. To stop engine: Release operator presence bail arm B6 (3). To start warm engine:

Lift and hold operator presence bail arm B6 (3). Pull starter rope B8 (4) rapidly and return starter grip slowly. Should the engine not start

in cold weather, press the primer. If the engine stops because fuel hast run out, refill fuel tank. Press the primer (Esprit 40 B/BK, 46 B three

times), (Esprit 40 T four times).

Starting Esprit 40 BA/40 TA/40 BAK/46 BA (fig. B5/B7/B8)

Place mower on level ground, not ontohigh grass. Throttle lever B7 (1) to „Betrieb“ (=run). Cold starting: Firmly press the primer on the

engine B5 (2), (Esprit 40 B/BA/BK/BAK, 46 B/46 BA three times), (Esprit 40 T/TA four times). Lift and hold operator presence bail arm B7

(3). Pull starter rope B8 (4) rapidly and return starter grip slowly. Self-propelled drive on: lift drive clutch bail arm B7 (5). Drive off: Release

drive clutch bail arm B7 (5). To stop engine: Release operator presence bail arm B7 (3). To start warm engine: Lift and hold operator

presence bail arm B7 (3). Pull starter rope B8 (4) rapidly and return starter grip slowly. Should the engine not start in cold weather, press the

primer. If the engine stops because fuel hast run out, refill fuel. Press the primer (Esprit 40 B/BA/BK/BAK, 46 B/46 BA three times), (Esprit

40 T/TA four times).

Mowing (fig. B9)

Always mow using throttle lever setting Power. Mow with throttle lever on „Betrieb“ position. Start engine with mower placed on level and firm

ground. Turn mower on lawn area already mown. Do not leave mower standing with engine running for longer than absolutely necessary.

Fixing of handle

ATTENTION! Take care that the switch cable does not become caught and crused when fol-ding the handle frame (fig. M2).

Disconnect spark plug cap and starter key (with electric-start-models) before proceeding!

Clean mower thoroughly after each mowing with cloth or brush.

Do not spray with water. Keep mower in a dry room.

Change oil only

While engine is warm and fuel tank empty.

Change oil after the first 5 working hours. Thereafter chane engine oil every 25 working hours and at the end of the mowing season. Change

engine oil more frequently if working under extreme and dusty conditions.

To drain the engine oil, remove oil filler cap, tilt machine slowly to side and allow oil to drain from the crankcase through the filler.

Cleaning of Spark Plug

Check and clean regularly, reset plug gap as required (Briggs & Stratton 0,76 mm, Tecumseh 0,70 mm).

Cleaning of air filter

Refer to the engine manufacturer‘s handbook supplied.

Cleaning operations and blade change - Esprit 40 B/40 BA/40 BAK/40 BK/46 B/46 BA (fig. W1)

Tilt the mower towards rear for cleaning operations and blade change: Detach spark plug cable. Fold upper part of handle forwards (avoid

damage to Bowden cables).

Cleaning operations and blade change - Esprit 40 T/40 TA (fig. W2)

When cleaning the mower and changing blades, lay the mower on its right hand side as illustrated. Pull off the spark plug lead.

Sharpening and changing blade (fig. W3)

Blade should always be sharpened by an approved Service Centre. Change blade according to drawing.

Gloves should be worn at all times when working on the blade. Remove ignition key and spark plug lead when working on the

blade.

Information for Service Centre, blade retaining screw to be tightened to: screw = 38-42 Nm.

Winter storage

• Drain fuel tank.

• Drain carburettor

- therefore start engine, keep it runninug until it automaticalli switches off.

• Clean the whole machine thoroughly

• Change oil, 4-stroke engine.

• Prepare engine for winter storage as follows:

- Remove spark plug

- Poor one spoon full of engine oil into spark plug hole

- Pull starter rope slowly to distribute oil evenly inside cylinder

- Replace spark plug but do not connect spark plug lead

- Pull starter rope until resistance is felt (valves are now closed)

• Store mower in a cool and dry place.

We recommend: Have your mower thoroughly checked once a year by approved Service Agent.

Maintenance

Operation

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

WOLF-Garten Esprit 40 BAK Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info